extend DSA to higher temperatures although they are less effective than Mo, Co, Ni and Mn. Chakravartty et al. reported that the nitride formers such as Al, Ti and V tie up a major fraction of nitrogen in the form of alloy nitrides and DSA is diminished in ferrictic-pearlitic steel [9]. As shown in Table 1, the concentrations of Mo, Ni, V, Al in Mat. B are even higher than those in Mat. A. From the previous studies, it is deduced that substitutional impurities such as Mo, Ni, V, Al also reduced DSA sensitivity in Mat. B. CONCLUSIONS J-R fracture resistance of SA516-Gr.70 steels is very sensitive to the loading rate and temperature due to dynamic strain aging. The difference of J-R fracture resistance levels and DSA behaviors between two heats of SA516-Gr.70 steels are mainly due to differences of pearlite to ferrite ratio and chemical composition such as concentrations of interstitial solute atoms. It was presumed that substitutional solute concentrations also affected DSA behavior in SA516-Gr.70 steels. ACKNOWLEDGEMENT This work has been carried out as a part of Reactor Pressure Boundary Materials Project under the Nuclear R&D Program by MOST in Korea. REFERENCES 1. USNRC (1987). Leak Before Break Evaluation Procedure, USNRC Report NUREG-800, Standard Review Plan. 3.3.6. 2. M. T., Migline et al. (1985). Effects of Strain Aging in the Unloading Compliance J test, ASTM STP 856, ASTM, Philadelphia,. 3. A. A., Marengo and J. E., Perez (1996). Nucl Engng Des. 167, 215-222. 4. J. H. Hong et al. (1997). KAERI Report, KAERI/CR-35/97. 5. A., Portein and F., Le Chatelier (1923). Compt. Rend. Acad. Sci., 176, 507-512. 6. A. S., Keh et al., (1968). Dislocation Dynamics, McGraw-Hill, New York,. 7. R. Stevenson : Metall. Trans. 11A (1980) 1909 8. J. D. Baird, A. Jamieson (1966). J. Iron Steel Inst., 204, 793. 9. J. K., Chakravartty et al. (1983). J. Nucl. Mater.,119, 51-58. - 6 -
RkJQdWJsaXNoZXIy MjM0NDE=