ICF10B

from that of α-titanium. Fatigue crack growth rate of β-titanium in helium was almost the same as that in vacuum, while that of α-titanium in helium was approximately twice that in vacuum at a given ∆K. Fractorgraphs of β-titanium specimens tested in vacuum, helium, argon and xenon at ∆K of 13 MPa m1/2 are shown in Fig. 3. Striations are clearly observed on fracture surfaces of specimens tested in argon and xenon, while less obvious striations are found on those tested in vacuum and helium. 10-8 10-7 10-6 10 20 Vac He air Vac Ar Xe da/dN (m/cycle) ∆K (MPam1/2) 30 Figure 2: Fatigue crack growth rate of β-titanium in gaseous environments Both an increase in crack growth rate and a change in fracture surface appearance indicate that even noble gases have interactions with a metal during plastic deformation. The difference in fracture surface appearance may be caused by the noble gas atoms entered the metal, not by simple adsorption on the surfaces. (Please note that the entrance of noble gas atoms has been confirmed on α-titanium [4].) The appearance of clear striations accompanies with an increase in crack growth rate. This may indicate that the entrance of noble gas atoms into the titanium matrix causes embrittlement and thus results in a change in deformation behaviour. Fatigue crack growth rate of α-titanium increased in a helium environment as compared to that in vacuum, while that of β-titanium alloy did not. Fracture surface appearance of α-titanium tested in the helium environment was similar to that in the other noble gas environments, while that of the β-titanium alloy was similar to that in vacuum. These differences may be caused by the difference in crystal structure. The interaction between titanium matrix and entered noble gas atoms may be affected by the difference in crystal structure, that is the size of spaces among the titanium atoms. However, further studies are necessary to understand the details.

RkJQdWJsaXNoZXIy MjM0NDE=