ICF10B

osmium and observed using a field emission-gun scanning electron microscope (FE-SEM). RESULTS AND DISCUSSION In-situ observation on propagating fatigue crack in PMMA In this study fatigue crack mostly grew into the craze accompanied the crack and the craze was broken at the midrib. This suggests that fracture surfaces were covered with the fragments of the craze. Previous studies [7, 14] also pointed out that fracture surfaces in PMMA must have thin fracture layer, which was demonstrated by on the evidence that color interference fringes observed on the surfaces. At low R-ratios of less than 0.5, however, fragments of the craze were hardly observed at the edges of the fatigue crack wakes. In further detail, when the crack just propagated at Kmax in a loading cycle, fragments of the craze had still remained at the edges of the crack just behind the crack tip, but the fragments disappeared in the subsequent cycle. This may be because the craze fragments were pushed down by contact between the fracture surfaces, in other words, crack closure. On the other hands, at an R-ratio of 0.7 the fragments remained at the edges of crack wakes after the subsequent cycles. Figure 3 shows the vicinity of the fatigue crack tip after the R ratio was changed from 0.5 to 0.7. This micrograph makes it clear that the craze fragments along the edges of the crack wakes disappeared at an R-ratio of 0.5 but remained at an R-ratio of 0.7. This result shows that closure should collapse the craze fragments layers on fatigue crack propagation in PMMA. Figure3: A micrograph of a fatigue crack tip, after the stress ratio was changed from 0.5 to 0.7 Striations on the fatigue fracture surface in PMMA In our previous study [15] we suggested that striations on fatigue fracture surfaces in PMMA might be formed by the contacts between fracture surfaces. This means that it is correct, pushing down the craze fragment layers in each cycle would make a striation. In FE-SEM observations, striations become less obvious on the fracture surfaces in the material with increasing R-ratio. Figure 4 (a) shows a fatigue fracture surface at which R ratio was just changed from 0.5 to 0.7. At an R-ratio of 0.5 striations, which are partly shown by several arrows in the figure, were narrowly observed, but were not observed at an R-ratio of 0.7 in spite of high magnification as shown in figure 4 (b).

RkJQdWJsaXNoZXIy MjM0NDE=