ICF10B

ORAL REFERENCE: ICF100880OR ELEVATED TEMPERATURE FRACTURE AND CRACK GROWTH IN TiAl BASE INTERMETALLICS Bilal Dogan GKSS Research Centre, Institute for Materials Research Max-Planck-Str., D-21502 Geesthacht, F.R.Germany ABSTRACT New materials and processes are bringing about radical changes in the aerospace and transport industry. Due to the high premiums tied to weight reductions in advanced engines the application of TiAl base intermetallic alloys look especially attractive because of their high specific modulus, high specific creep strength, and good oxidation resistance at elevated temperatures. The fracture and high temperature crack growth behaviour of a γ-TiAl base intermetallic alloy, Ti48Al2Cr, with a duplex microstructure were studied at 700°C. Compact tension (CT) type specimens were tested both with EDM slit notches and fatigue precracks. The loading mode was varied to study the applicability of different test techniques. The present investigation showed that the inhomogenity in microstructure needs to be considered in fracture toughness testing and crack growth assessment of TiAl base intermetallics. The starter sharp crack may be introduced by fatigue precracking and also by EDM provided notch root radius ρ is 0.05mm. The crack growth rate data showed loading mode dependence. Brittle fracture directs attention to the crack length measurement method that requires improvement. The crack growth rate data were correlated with K and C*(t), and the applicability of the existing test method for crack growth characterisation of TiAl intermetallics is discussed. The emphasis is placed on the correlation between microstructure, fracture and crack growth behaviour of the alloys. ≤ KEY WORDS: TiAl, Intermetallics, High Temperature, Fracture, Creep Crack Growth INTRODUCTION Enormous effort has been made in the field of intermetallic materials during the past two decades [1-3]. The work was concentrated on the light weight γ-TiAl base intermetallic alloys which are considered for future high temperature engineering applications to replace the current Ni and Ti base alloys. Several potential applications have been identified for TiAl-based alloys in the aerospace, automotive and turbine power generation markets. Aerospace industry is pursuing the implementation of these alloys in aircraft engine components [4]. Considering the potential application temperatures of about 700°C, the γ -TiAl base intermetallic alloys stand as promising materials for engineering applications provided the problems of relatively low fracture toughness and fast crack growth rates are overcome. The concern is that component life will then be limited in the presence of relatively small existing or in service-initiated defects or flaws. Therefore, the understanding of mechanisms of deformation, fracture and high temperature crack growth need be improved that has been recognised and being worked on intensively [2,5-9].

RkJQdWJsaXNoZXIy MjM0NDE=