ICF10B

ICF100156OR EQUILIBRIUM LENGTH OF A ZENER-BARENBLATT NANOCRACK WEDGED OPEN BY A DISCLINATION DIPOLE Mao S. Wu Department of Engineering Mechanics, University of Nebraska-Lincoln, Lincoln, NE 68588-0526, USA ABSTRACT The aim of this paper is to investigate the equilibrium length of a stable, mode I nanocrack wedged open by a disclination dipole and subjected to a remote stress. The crack is assumed to be of the Zener type with its head coinciding with the negative disclination of the dipole. Also assumed is the Barenblatt model, in which cohesive zones carrying the theoretical tensile stress exist at the crack extremities. The resulting ZenerBarenblatt crack is modeled by edge dislocations. Exact equations for computing the crack length and cohesive zone lengths are presented. Numerical results show that for a stable nanocrack 10-9 to 10-8 m in length: (i) the cohesive zones constitute a significant portion of the crack, (ii) the traction-free zone length is significantly less than the predicted length of a purely elastic Zener crack with no cohesive zones, (iii) the traction-free zone length increases with the disclination dipole strength w and arm length 2a, and (iv) the cohesive zone at the crack head decreases in length with both w and 2a while that at the crack tip increases in length with these parameters. KEYWORDS Zener-Barenlatt crack, disclination dipole, cohesive zones 1. INTRODUCTION Disclinations have been used to model various dislocation ensembles in materials undergoing transformation plasticity, e.g., twinning and strain-induced martensitic transformation. In particular, the front of a deformation twin can be modeled by a wedge disclination dipole [1, 2]. When a twin is blocked by an intersecting twin, a very short crack (nanocrack with length 10-9 to 10-8 m) can nucleate from the negative disclination of the dipole. The characteristics of such a nanocrack have only been recently predicted [3]. In this paper, a stable nanocrack subjected to remote mode I loading and wedged open by a disclination dipole is further studied. The wedge-shape crack is modeled as a Zener crack, which is characterized by the crack head opening bT. For a very short crack with length 10 – 100 times the Burgers vector magnitude, however, the classical traction-free Zener crack may no longer be physically valid. Consequently, the Barenblatt model is invoked, in which atomistic cohesion exists at the crack extremities. Tractions, which for simplicity are taken to be constant and equal to the theoretical tensile stress, act over these cohesive zones. Of primary interests then are the total length of such a Zener-Barenblatt crack, the cohesive zone lengths, and their dependence on the disclination parameters, i.e., the dipole strength w and the dipole arm length 2a. Moreover, it is of interest to

RkJQdWJsaXNoZXIy MjM0NDE=