as shown in Fig.8. The r values are obtained from√areaA values with the following relation. r = √areaA √π (13) Let us consider the radius of circle obtained from a cut sphere. The number of circles whose r is larger than r1 per unit area, MA0(r1), has a mutual relation with MV0(R1) [23]. Especially if MV0(R1) is supposed with Eqn.8, MA0(r1) is expressed as follows. MA0(r1)=r 2π ν λ³ r1 λ´ 1−ν 2 ¯NV0 expn−³ r1 λ´ νo (14) Figure 9 shows the experimental data for MA0(√areaA) of eutectic Si, Fe compound and porosity of each material. The ¯NV0, λ and ν values of Eqn.8 were determined after drawing the curve of Eqn.8, which is an optimumfit to the data. Figures 12 and 13 showMV0(R) and MS0(√areaP), respectively. When the inspection area, A, is taken as the area whose stress is (1 ∼0.9)σmax on the specimen surface, A=60 mm2 in case of the present specimen. Figure 17 shows FSmax(√areaPmax) on the present area. It is possible that the surface porosity is the fracture origin in AC4B-T6. √areaA [µm] MA0 [1/mm2] Figure.9: MA0(√areaA) R [µm] MV0 [1/mm3] Figure.10: MV0(√areaR) √areaP [µm] MS0 [1/mm2] Figure.11: MS0(√areaP) Comparison between predicted and experimental fatigue life A cumulative distribution of √areaP values observed on the fracture surface was obtained from Fig.7 using the mean rank method. Figure 13 shows both the cumulative distribution of porosity. As results of Fig.13, it is found that the estimation method for the probability distribution of √areaPmax is valid and the maximum value of √areaP of cut porosity with the specimen surface controls the fatigue strength of the present aluminum cast alloy. Therefore the fatigue life reliability of the present specimen shown in Fig.5 can be estimated by using Eqn.10 which expresses the statistical characteristics of √areaPmax of porosity, and Eqn.11 which expresses the fatigue life due to fatigue crack growth. Namely, the fatigue life reliability such that the fatigue life is greater than Nf1,FNf, is FNf(Nf1)=FSmax(√areaPmax1) (15) Nf1 = E C5 σS³ σS σa´ 6 lnh d qπ 8√areaPmaxi (16) Figure 14 shows the predicted results from meso-level data and experimental data. As a result, the following is found. Although the fatigue life characteristic of AC4B cannot be evaluated quantitatively from the macro-scale fatigue characteristic of Fig.7, the characteristics can be evaluated quantitatively from the meso-scale material characteristics with Table 3, and Figs.12 and 13. CONCLUSION 1. The prediction method for the data scatter of high-cycle fatigue life has been proposed with microscope observations for cross-section size distribution of particles cut by a cutting plane. 2. The predicted results have been confirmed for aluminum cast alloy.
RkJQdWJsaXNoZXIy MjM0NDE=