ICF10B

EXAMINATION AND ANALYSIS Visual Examination of Failed Wheel The fragments of the fractured disk were pieced together, as shown in the schematic diagram of Figure 1. Some key features are immediately visible. 3 C 4 2 B A 1 Figure 1: Schematic of the failed wheel. There are four large cracks in the fractured disk. A circumferential crack (labeled “1” in Figure 3) runs completely round the disk along the circumferential footprint of the clamping washer. The fibers are cleanly broken. The other three cracks are radial cracks. Crack “2” runs at 90° to one fiber direction. The bridging fibers are cleanly broken along the length of the crack. Cracks “3” and “4” run at 45° to the fiber directions. They are characterized by large areas of fiber delamination and by considerable loss of the abrasive material. Crack “3” initiates in a non-radial direction, but changes direction to become a radial crack. As expected, therefore, all cracks show a preference for propagating in one of the directions of principal stress, that is, the radial or circumferential direction. The injury was caused by fragment “B”. Material Testing Compact tension specimens and bend beams were fabricated from samples of the failed cut-off wheel as well as from two exemplar cut-off wheels. These samples were used to determine fracture toughness of the matrix material and the bending strength, taking into account the contribution of the fiber mats, and the effect of fiber orientation. Samples were cut from each wheel at 0°, 45° and 90° with respect to the warp direction of the fiber weave pattern on the top surface of the disk. The relative orientations of the fiber patterns on either surface of the disk varied for each wheel. The fibers on the top and bottom surface of the failed wheel were nearly aligned with each other (relative angle ~6°) while those on the exemplar wheels where not aligned (relative angles ~25° and 60°). This was a consequence of the manufacturing procedure, which neither specified nor ensured the relative fiber orientation. Compact Tension Tests Compact tension tests were conducted to determine comparative measures of fracture toughness for the different wheels, and for different fiber orientations. The test sample geometry and dimensions are in accordance with ASTM E399 [2]. Typical load displacement curves from one wheel and specimen orientation are shown in Figure 2. In all cases, cracking initiates in the matrix. The toughness of the matrix

RkJQdWJsaXNoZXIy MjM0NDE=