ORAL/POSTER REFERENCE: ICF100231OR FATIGUE AND FRACTURE PROPERTIES OF Co-Fe ALLOYS AT 1500 C V Filardi1, E Guglielmino2, S J Harris3, T H Hyde3, R V Major4, 1DIIEM – Università degli Studi di Catania - Viale A. Doria, 6 – 95125 Catania - Italy 2DCIIM – Università degli Studi di Messina – S. Sperone 31 – 98166 Messina - Italy 3School of Mechanical, Materials, Manufacturing Engineering and Management – University of Nottingham -University Park -Nottingham, NG7 2RD UK 4CARPENTER Specialty Alloys UK, Crawley, Sussex, UK ABSTRACT The results of a series of fatigue tests performed on two Co-Fe alloys at 150oC are reported. The ratio of the minimum to maximum load, R, in all tests was 0.1. Both materials behaved in a similar manner, with a fatigue limit (ie maximum stress to cause failure in 106 cycles) of 800 MPa (ie a stress range of 80 to 800 MPa). Following initiation, a short period of fatigue crack growth is followed by a fast fracture process. During fast fracture, the crack bifurcates; the bifurcation angles lie in the range 32o to 39o. KEYWORDS Fatigue, Co-Fe, Fast Fracture, Bifurcation. INTRODUCTION Cobalt iron alloys, are used in a wide variety of engineering applications, because they can be made with a combination of high mechanical strength and have a high level of magnetic saturation performance. In some situations, it is also necessary for these materials to operate at elevated temperatures and under variable loading conditions, such that fatigue must be considered as a possible failure mode. This paper contains the results of a series of tests performed on two Co-Fe alloys developed for use in a variable frequency generator for aeroengine applications. The materials, designated Rotelloy® 7 and Rotelloy® 8, were supplied by Carpenter Technology UK, as part of a DTI funded project managed by Lucas Aerospace. TEST CONDITIONS, SPECIMEN GEOMETRY AND LOADING
RkJQdWJsaXNoZXIy MjM0NDE=