crack lengths at the onset of fast fracture were generally in the range 0.15 to 0.3mm. This indicates (1) that, on the basis of an LEFM analysis, the fracture toughness KIC, of the material is approximately 25 MPam0.5. Using this value of the KIC with a flow stress of 1000 MPa (2,3) leads to a crack tip plastic zone size of approximately 0.03mm. Although this is not insignificant compared with the crack length at the onset of fast fracture (0.15 to 0.3mm), it is small enough to ensure that it is reasonable to use KIC = 25 MPam0.5 as the fracture toughness to estimate the load bearing capacity of a component made from the Co-Fe alloys. A detailed explanation of the fracture process will be the subject of a future paper. This will include an explanation of the relationship between KIC, the bifurcation angle and the length of crack at the onset of branching. CONCLUSIONS • The fatigue limit for the alloys (with R = 0.1) is about 800 MPa. • Fatigue initiation is followed by a relatively short period of fatigue crack growth. • The KIC for the materials is about 25 MPam0.5. • Following a short period of fatigue crack growth, fast fracture initiates, and the crack growths perpendicular to the applied stress axis. • Crack branching occurs when the cracks have propagated to lengths in the range 0.5 to 1.5mm. ACKNOWLEDGMENTS The authors would like to thank the DTI, Lucas Aerospace and Carpenter Specialty Alloys UK for their financial support of the research reported in this paper and for granting permission to publish the paper. They also would like to acknowledge the advice given by Mr. K. Dinsdale for the SEM analysis of fractures. REFERENCES 1. D P Rooke and D J Cartwright, "Compendium of Stress Intensity Factors", London, HM Stationery Office, 1976. 2. R V Major and W Gemmell, "Soft Magnetic Alloys Combining High Saturation and High Strength", Proceedings of conference on Soft Magnetic Materials 96, February 1996, San Francisco. 3. R V Major and V Samadian, "Physical Metallurgy and Properties of a New High Saturation Co-Fe Alloy", J Materials Engineering, Vol 11(1), 1989, pp 27-30.
RkJQdWJsaXNoZXIy MjM0NDE=