POSTER REFERENCE: ICF100257PR FATIGUE BEHAVIOR OF A PULTRUDED GLASSREINFORCED POLYMER-MATRIX COMPOSITE MATERIAL L. B. Godefroid1, W. A. Morais1, G. P. Silva1 and J. A. Martins2 1 Dept. of Metallurgical and Materials Engineering, School of Mines, Federal University of Ouro Preto, Campus Universitário Morro do Cruzeiro – Ouro Preto – 35400-000 – MG – BRAZIL 2 ENMAC Composite Materials Ltd. Rua Joaçaba,10 – São José dos Campos – 12238-530 – SP - BRAZIL ABSTRACT Most of the commonly used continuous fibers-reinforced polymer composite materials work with pultrusion. This process can produce a variety of reinforced solid, tubular or structural profiles, with very interesting chemical, physical and mechanical properties. Recently, the increase in the use of pultruded composites through critical applications in automobile and aerospace industries requires a complete and precise knowledge of its properties, mainly the fatigue resistance. This paper presents several aspects of the fatigue behavior of a glass-reinforced polymer composite, with particular emphasis on the Wöhler curve (S-N curve). Effects of R-ratio, frequency and overloads were studied. Damage by fatigue is measured by two different forms: residual strength obtained from tensile tests, and continuous measure of deformation of the composite material from fatigue tests. KEYWORDS Fracture, Fatigue, Damage, Composite Material. INTRODUCTION Without doubt fatigue is the most serious damage process in using engineering materials. With composite materials, as the same form of any other material, the major utilization problem is fatigue. However, in the most utilized composite material – fiber reinforced plastics –the formation and propagation of a crack or a few cracks does not happen, as in metals or ceramic materials. Due to its own inhomogeneity, these does not exist an unique (or few) crack propagating freely in the material’s structure. A typical fiber reinforced composite continually damages under fatigue. The experimental verification of this dynamic fatigue response of composites can be found in many works [1-5]. The generated defects may reach a stable condition sometimes called [4] “characteristic damage stage” or CDS. In this condition the mechanical properties of the composite slightly change during the fatigue process. The alteration on mechanical properties is almost always easier and more representative to measure and to register than either a crack size or an effective crack size in fatigue of composites.
RkJQdWJsaXNoZXIy MjM0NDE=