POSTER REFERENCE: ICF100508PR FLOW STRESS OF STEEL AT LARGE STRAINS AND HIGH STRAIN RATES G. Pape*, A. Bakker* and M. Janssen* * Delft University of Technology, Laboratory of Materials Science, Rotterdamseweg 137, 2628 AL, Delft, The Netherlands ABSTRACT In this study an experimental approach has been taken to investigate the strain rate influence on ductile behaviour of steel. A high-rate servo-hydraulic tensile machine has been used to perform experiments on steel. Deformation has been analysed using a high-speed drum-camera. Digital image processing techniques yielded geometry information, which has been used to derive the true stress-strain curve after localisation of deformation. Several correction procedures were applied to derive the von Mises flow stress of the material. Analytical procedures as well as a numerical technique have been used. A modified Johnson-Cook relation has been applied to fit the experimental data. This relation gives a functional dependence of the material flow stress of the plastic strain and plastic strain rate. The influence of the temperature has been considered as well. The material flow stress increases at increasing strain rate for strains below necking, but tends to decrease at higher strains. The flow stress description used here can only be used for monotonic loading conditions, and does not provide a constitutive model for any deformation history. Modelling of tensile specimen experiments using the strain rate dependent flow stress shows good agreement with measurement data. Localisation behaviour is strongly influenced by the strain hardening and needs a proper description to account for the total deformation. KEY WORDS Flow Stress, High Strain Rate, Experiment, Model, Steel, Image Processing INTRODUCTION Research for the Royal Netherlands Navy on the vulnerability of warships has resulted in a detailed study on the failure behaviour of explosively loaded panels inside ship structures. This study contains on the one hand a determination of the material response to high strain rate deformation, and on the other hand an investigation of the failure behaviour of the material. Analysis of the failure behaviour was performed experimentally as well as numerically, and also the influence of the strain rate has been taken into account. This paper is concerned with the experimental determination of the flow stress of the material and a proper description of the flow stress as a function of plastic strain and strain rate. Failure investigations have been presented in an additional paper [1].
RkJQdWJsaXNoZXIy MjM0NDE=