Proceedings, 10th International Congress of Fracture (ICF10), Honolulu, Hawaii, 3-7 December 2001 Oral Reference: ICF100964OR FRACTURE AND CREEP RUPTURE BEHAVIOR OF NOTCHED OXIDE/OXIDE AND SiC/SiC CMC Reji John1, Dennis J. Buchanan2 and Larry P. Zawada1 1 Air Force Research Laboratory, Materials and Manufacturing Directorate (AFRL/MLLMN) Wright-Patterson AFB, OH 45433-7817, USA 2 University of Dayton Research Institute Dayton, OH 45419, USA ABSTRACT Woven Oxide/Oxide and SiC/SiC ceramic matrix composites (CMC) are targeted for high-temperature aerospace applications such as combustors, combustor liners, exhaust washed structures, exhaust nozzle flaps and seals, and blade outer air seals. Some of these components contain stress concentration sites such as holes and attachment points. During service, these locations will be subjected to long-term exposures. Hence, the knowledge of the effect of sustained (creep) loading on the deformation and rupture of notched Oxide/Oxide and SiC/SiC composites is required for durability assessment. The results from creep tests of unnotched and notched Nextel™720/Alumina-Silica (Nextel™720/AS-0) and Melt Infiltrated (MI) HINICALON-Type-S/SiC (MI HI-NICALON-S/SiC) are discussed in this paper. Nextel™720/AS-0 was evaluated at 1100°C and MI HI-NICALON-S/SiC at 1200°C in laboratory air. In the case of large notches, i.e., notch length greater than the average tow size, the notch-sensitivity increased significantly under sustained loading for both composites. Nextel™720/AS-0 specimens with straight-through effusion holes (hole diameter = 0.5 mm) were also subjected to sustained loading at 100MPa/1100°C. In this case, the presence of effusion holes did not affect the overall creep response. KEYWORDS ceramic matrix composite, creep, effusion holes, fracture, notch-sensitivity, oxide/oxide, sic/sic, woven cmc INTRODUCTION Woven Oxide/Oxide and SiC/SiC ceramic matrix composites are being demonstrated for high-temperature aerospace applications with temperature requirements in the range of 1000-1300°C [1-4]. Current targeted aerospace turbine engine components, such as combustors, combustor liners, divergent flaps and seals, contain bolted attachment points and cooling holes. Local stresses in these regions often exceed the proportional limit of the composite, resulting in damage and crack initiation. Hence, component design using CMC will require knowledge of the notched fracture behavior and damage progression under service thermomechanical loading conditions. Most of the results on the notched behavior of Oxide/Oxide and MI SiC/SiC CMC correspond to monotonic tensile loading [5-14]. Recently, John et al. [8,9] and McNulty et al. [12] studied the effects of long-term loading on notched Oxide/Oxide at 1100°C and MI SiC/SiC at 815°C, 1 / 6
RkJQdWJsaXNoZXIy MjM0NDE=