ICF10B

ICF1001038OR FRACTURE BEHAVIOR OF A CORRODED ANNULAR PLATE UNDER A MULTI-AXIAL STRESS STATE M.OHASHI National Research Institute of Police Science 6-3-1, Kashiwanoha, Kashiwa, Chiba277-0882, Japan ABSTRACT For the purpose of risk assessment of damaged structure, bend tests were carried out on a corroded annular plate prepared from the oil storage tank. Corrosive attack occurred extensively on the outer surface of the annular plate. Seriously developed cracking was noted in the high deflection region depending upon the degree of corrosion damage. From successive observation of crack growth behavior on the roughened corroded surface, it was clearly recognized that the multiple cracks, initiated around pits, grew rapidly not only by crack growth by itself, but also by coalescence with other neighboring cracks under the influence of plastic constraint derived from the welded joint. Then, it should be emphasized that the development of serious cracking, leading to a catastrophic failure, was expected to occur on a corroded component through the linking up of multiple cracks under a multi-axial stress state. KEYWORDS risk assessment, corrosion damage, annular plate, multiple cracks, crack coalescence, stress concentration, plastic constraint. INTRODUCTION Some of the existing structures degrade in service resulting from various types of deterioration. The reliability assessment of the damaged structure should be considered to minimize the risk of failures. Research activities are mainly concerned with degradation occurring in high temperature power plants, commonly known as creep damage and temper embrittlement . However, corrosion of the structural component is the simplest and most common form of degradation, and occurs frequently under normal service condition. Besides, a generally uniform corrosion produces a rough surface on the component in some situations. In such circumstances, a more serious problem should be supposed to occur under a multi-axial stress state around the welded joint. Hence, the reliability of the corroded component should be considered against various loading or stress state that would be envisaged to be applied in service. In this study, the fracture behavior of a corroded annular plate, prepared from the oil storage tank, was investigated under bending load, to identify the significance of corrosion damage for risk assessment. EXPERIMENTAL PROCEDURE Material and Bend Specimen L-shaped bend specimens were machined from the welded joint between the shell plate and the annular plate of the oil storage tank. The geometry and dimensions of the bend specimen is given in Fig.1. The general appearance of the corroded surface is a roughened one with a

RkJQdWJsaXNoZXIy MjM0NDE=