ICF1009740R FRACTURE BEHAVIOUR OF INJECTION MOLDINGS WITH WELD LINE H. Hamada1, K. Yamada2, K. Tomari2 and T. Harada2 1 Advanced Fibro-Science, Kyoto Institute of Technology, Matsugasaki, Sakyo-ku, Kyoto, 606-8585, JAPAN 2 Plastics Department, Osaka Municipal Technical Research Institute, Morinomiya, Joto-ku, Osaka, 536-8553, JAPAN ABSTRACT Weld lines are fatal defects in many injection moldings. Fracture behaviour of weld line is investigated in double torsion (DT) test using injection-molded polystyrene plates with a circular hole. The load-displacement curve showed irregular fluctuation corresponding to the alternate slow and rapid crack propagation. When the crack propagated rapidly, ripple marks appeared on the fracture surface, which were affected by the weld line. The ripple marks could be classified into two patterns, pattern I the ripple marks indicate that the crack propagated inwardly from the surface, and pattern II the ripple marks indicate the crack propagated from the mechanically introduced pre-notch. Pattern I was assumed to show the effect of V-notch on the weld line surface because the pattern was observed only in the fracture surface with a weld line. However, it was found that pattern I appeared even where there was no V-notch on the surface. It can be concluded that V-notch on the weld line surface does not affect the fracture behaviour, while it affects the visual defects of injection moldings. KEY WORDS Injection molding, weld line, polystyrene, fracture toughness, double torsion INTRODUCTION Weld lines that occur wherever two or more melt fronts meet cause reduced mechanical properties and visual defects of injection moldings. The reduction of mechanical properties is considered to be caused by poor intermolecular entanglement at the weld line, molecular orientation induced by the fountain flow, and the stress concentration effect of surface V-notch. Although the effect of weld line on the strength of injection moldings can be easily evaluated using dumbbell specimens which are molded in
RkJQdWJsaXNoZXIy MjM0NDE=