ICF10B

The fracture problems of piezoelectric materials have received much attention in the last ten years. Thus, vast amount of theoretical results have been obtained by many researchers [1-8]. However, nearly all the previous analyses were based on the assumption of impermeable or permeable crack. In fact, these two extreme cases are not realistic. Since the dielectric constant of the air or vacuum inside the crack is neither zero nor the dielectric permittivity of the material [3, 7], the crack problems in a piezoelectric material should be treated as electric inclusion problems. Consequently, Sosa and Khutoryansky [9] used the series expansion method to address the plane problem of a transversely isotropic piezoelectric medium with an elliptical hole. Many fracture criteria for piezoelectric materials have been proposed in the recent years, e.g., the total potential [4,6], the mechanical [8] and the local [10] energy release rates, and the energy criterion considering domain switching dissipation [11]. Pak [4] found that the presence of applied electric field always reduced the total potential energy release rate. This implies that a crack is impeded by the electric field regardless of its direction. This conclusion contradicts the existing experimental data. Later, Park and Sun [8] proposed to use only the mechanical part of the energy as a criterion by arguing that fracture is a mechanical process and, therefore, it should be controlled by the mechanical part of the energy release rate. But, this argument is unsound because there is no fundamental reason to separate a physical process into an electric part and a mechanical part, in view of the fact that all mechanical forces are of electromagnetic origin. As a result, Gao et al. [10] proposed a criterion based on the local energy release rate of an electrically yielded crack. However, the effect of domain switching cannot be accounted for using this model. In line with Griffith's theory on mechanical fracture, Fang et al. [11] proposed a criterion based on energy balance with the consideration of domain switching dissipation. However, they only proposed an energy balance approach and the results are the same as those of Gao et al [10]. Recently, Shen and Nishioka [12] used strain energy density theory to develop a fracture criterion for piezoelectric materials. Their theoretical result agrees qualitatively with the empirical evidence by assuming impermeable crack. In the present study, the energy density fracture analysis of an elliptic cavity or a crack, in a transversely isotropic piezoelectric solid subjected to remote loading, is carried out. This study adopts the approach and the assumption of exact electric boundary conditions employed by Sosa and Khutoryansky [9]. First of all, a surface layer criterion [13] is used to locate the position where the fracture of the elliptic cavity is expected to initiate. The direction of crack initiation and subsequent post-failure can be described by the total energy density factor, S, from which the critical loads for fracture can be predicted. SOLUTION FOR AN ELLIPTIC CAVITY Consider a central elliptic cavity of major and minor semi-axes, a and b, respectively, embedded in an infinite poled piezoelectric ceramic, which is subjected to a remote in-plane electrical loading, Ez ¥, and mode I mechanical loading, szz ¥ as shown in Figure 1. The cavity is assumed to be filled with a dielectric medium of permittivity, e0, and it is free of traction force and charge. The ceramic is poled in the positive direction of the z axis.

RkJQdWJsaXNoZXIy MjM0NDE=