ICF10B

ORAL/POSTER REFERENCE: ICF100409PR FRACTURE INITIATION AND CRACK GROWTH – COHESIVE ZONE MODELING AND STEREOSCOPIC MEASUREMENTS C.R. Chen1*, I. Scheider2, T. Siegmund3, A. Tatschl4, O. Kolednik4 and F.D. Fischer1 1 Institute of Mechanics, Montanuniversität, A - 8700 Leoben, Austria 2 GKSS Forschungszentrum Geesthacht GmbH, D - 21502 Geesthacht, Germany 3 School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907-1288, USA 4 Erich Schmid Institute of Materials Science, Austrian Academy of Sciences, A - 8700 Leoben, Austria ABSTRACT The purpose of this paper is to study the application of a cohesive zone model, which is appropriate for the use with 3D-elements, for the numerical simulation of the crack growth in a Compact Tension specimen made of a mild steel. The main problem is how the two parameters which control the crack growth in the model, the cohesive energy Γ0 and the cohesive strength Tmax, can be determined. A procedure is proposed to determine the variation of the parameters along the crack front, Γ0(z) and Tmax(z), by using the local crack growth data in the specimen center and at the side surfaces and 2D modeling under plane strain and plane stress conditions, as well as the measurement of the variation of the critical crack tip opening displacement, CODi(z), along the crack front. The comparison between the experimental data and the numerical simulation reveals that the parameters of the cohesive zone model change during (the first stages of) crack extension. KEYWORDS numerical simulation, 3D cohesive zone model, cohesive strength, fracture initiation, crack growth, critical crack tip opening displacement, automatic fracture surface analysis, stereophotogrammetry INTRODUCTION The cohesive zone model has been increasingly applied for the numerical analysis of crack propagation, first, only for brittle materials that exhibit cleavage fracture and, later, also for tough materials which fail in a micro-ductile mode [1]. It uses a traction-separation law, i.e. a special curve relating the separation stress, T, to the displacement, δ, to model the behavior of the material in the process zone in front of the crack tip. The various traction-separation laws for micro-ductile crack growth have a common feature: with the increase of separation the traction increases, reaches the peak value, called the cohesive strength, Tmax, and then decreases to zero when the separation reaches a critical value, δ0. The area under the traction-separation curve is the separation energy, Γ0, which represents physically the specific work required for the formation of the dimple structures on the two fracture surfaces [2]. It has been found that the exact shape of the T- δ curve has little effect on the crack growth behavior [3]; important are the magnitudes of the parameters Tmax and Γ0. In the application of the cohesive zone model to ductile fracture, most studies have been performed under either plane strain or plane stress conditions. However, to model the crack growth in a specimen with smooth * on leave from the Institute of Metal Research,Chinese Academy of Sciences, Shenyang, China

RkJQdWJsaXNoZXIy MjM0NDE=