Figure 1: Specific fracture energy of cement-based materials as function of maximum aggregate size. The lowest fracture energy is measured on pure hardened cement paste. In this case the maximum aggregate size is estimated to be 0,01 mm which corresponds to the dimension of the remaining unhydrated clinker particles. The highest value is observed in dam concrete with a maximum aggregate size of 120 mm [5]. In between the influence of maximum aggregate size on fracture energy can be described by a power function. Gf = a⋅Φmax n (1) From the data shown in Fig. 1 one obtains the following values for the parameters a and n in equ. (1): a = 80,6 and n = 0,32 [5]. In pure hardened cement paste and in fine mortar a crack can develop along a plane. The small and strong particles impose minor deviations from an ideal fracture surface only. In Fig. 2(a) a typical flat fracture surface of a mortar with a maximum aggregate size of 2 mm is shown. In Fig. 2(b) a fracture surface of normal concrete with a maximum aggregate size of 32 mm is shown. As most aggregates (river gravel) are stronger than the cement-based matrix a crack is forced to run around the inclusions. From Fig. 2(b) it can be clearly seen that a crack once it meets an aggregate either has to run out of the plane and leaves a blank aggregate surface behind or it runs in the opposite direction. In the latter case the aggregate is torn out of the matrix. The negative imprints can be seen in Fig. 2(b). Obviously the necessary fracture energy increases with the maximum aggregate size if the size distribution remains similar. In contrast to the energy consuming crack formation in normal concrete a crack in high strength concrete runs through the inclusions and forms approximately a plane as observed on fine mortars and pure hardened cement paste (Fig. 2(c)). In this case mechanisms of mechanical interaction between inclusions and matrix cannot be activated. This leads to the more brittle behaviour of high strength concrete. By means of the well-known model „numerical concrete“ [6] damage and crack formation in normal and high strength concrete will be simulated. Finally results obtained will be applied to predict shrinkage cracking under different boundary conditions.
RkJQdWJsaXNoZXIy MjM0NDE=