ICF10B

ICF100371OR FRACTURE OF NANOSTRUCTURED FCC METALS F. Ebrahimi, Z. Ahmed K. L. Morgan and A. J. Liscano Materials Science and Engineering, University of Florida P.O. Box 116400, Gainesville, FL 32611 ABSTRACT Nanocrystalline nickel and nanolayered structures of nickel and copper were produced by electrodeposition techniques. The analysis of the fracture surfaces of tensile specimens from these materials revealed that the low tensile elongation of nanostructured metallic materials is associated with a strong tendency to strain localization and the presence of pores in the microstructure. KEYWORDS nanostructures, nanocrystalline, multilayers, electrodeposition, nickel, copper, fracture, ductility INTRODUCTION The term “nanostructure” has been used to describe: (1) materials with at least one of their physical dimensions in the nano-range (e.g., particles or wires with nano-size diameters) and (ii) bulk materials (physical dimensions much larger than nano-size) whose microstructural constituents are in the nano-range (e.g., nanocrystalline and nanolayered materials). The nano-size is conventionally referred to lengths less than 100nm [1]. Due to the confinement of dislocations, bulk metallic nanostructures have very high yield strengths. However, the tensile testing results indicate that these materials exhibit low total elongations [2]. Processing defects have been suggested to be the cause of the low ductility of nanocrystalline FCC (face-centered cubic) metals produced via the gas condensation method [3]. We have been successful in fabricating almost defect free nanocrystalline and nanolayered metallic structures from FCC metals using electrodeposition techniques [4]. This paper presents results regarding the fracture behavior of nanocrystalline nickel and nanolayered nickel/copper materials and discusses the low elongation of metallic nanostructures. EXPERIMENTAL PROCEDURES The details of the fabrication of the nanomaterials using electrodeposition techniques are given elsewhere [4-7]. The deposits were in the form of discs with a 35mm diameter and were grown on copper substrates, which were subsequently dissolved. The deposits had a thickness between 25 to 40µm. Free-standing tensile specimens with a gage length of 10mm were prepared by hand grinding and were tested at a strain rate of 2x10-4 s-1. At least two tensile specimens were tested per deposit. The fracture surfaces were studied using scanning electron microscopy (SEM).

RkJQdWJsaXNoZXIy MjM0NDE=