ICF10B

formed layer by Na2SO4 corrosion 1/ d π and residual 4 point bending strength σR was investigated and shown in Figure 4. Also in this figure, fracture toughness data [4,5],i.e., KIC=3.5 MPa m for SiC and KIC=6 MPa m for Si3N4 were indicated by solid lines. As a result, it was indicated that the residual bending strength of Si3N4 decreased as the increase of square root depth of babble formed layer in case when the fracture of specimen was initiated from formed babble. For this reason, the residual bending strength of Si3N4 ceramic was controlled by KIC value calculated based on depth of babble formed layer. On the contrary, in case of SiC ceramic, the residual bending strength data can not plotted on any straight line which showed KIC=σ R dπ =Const, where σR means residual bending strength. Therefore, it becomes clear that the residual bending strength after high temperature corrosion can not be uniquely evaluated from the fracture mechanics view point evaluated based on the babble formed layer depth in case of Si-based ceramics. In the followings, detailed examinations of facture surface morphologies especially bubble shape which governed the residual bending strength after high temperature corrosion test were conducted and shown in Figure 5. From the results shown in this figure, it was recognized that there was clear difference between the corroded morphology and bubble morphology formed on Si3N4 and SiC ceramics. In case of Si3N4 ceramics corroded by molten salt, continuous bubble formation was usually recognized in entire coated molten salt surface layer. On the contrary, local single bubbles were generated discontinuously in the coated molten salt layer in case of SiC ceramics. Therefore, the fracture of specimen was initiated from the local single bubble. For this reason, in case of SiC ceramics, KIC value evaluation based on fracture origin defect area was introduced employing the following equation [6]. area K π Ⅰ 0 max IC 0.629 K σ = = (4) Then, correlation between KIC values evaluated based on defect area and residual bending strength were obtained and shown in Figure 6. Judging from the results shown in Figure 6, the residual bending strength after high temperature corrosion can be plotted around the straight line showing KIC=0 0 .629 σ =3.5MPa m in case of SiC. Therefore in this case, it was indicated that the residual bending strength of SiC decreased as the increase of square root defect area. For this reason, the residual bending strength of SiC ceramic was controlled by KIC value calculated based on defect area. area π 0 50 100 150 0 200 400 600 800 * * Depth of Babble Formed Layer 1/(πd)1/2 [m1/2] 4 Point Bending Strength [MPa] * ;Bubble is not fracture origine KⅠC=6[MPa(m1/2)] KⅠC=3.5[MPa(m1/2)] SiC 1173[K] SiC 1273[K] SiC 1373[K] Si3N4 1173[K] Si3N4 1273[K] Si3N4 1373[K] Si3N4 Figure 5: FE-SEM Photographs of Fracture Surface (d) 1173K (f) 1373K SiC (b) 1273K (e) 1273K (c) 1373K (a) 1173K Figure 4: Relation Between Depth of Babble Formed Layer and Strength 800 [MPa] SiC 1173[K] SiC 1273[K] SiC 1373[K] Si N 1173[K]

RkJQdWJsaXNoZXIy MjM0NDE=