ICF10B

The figure 4 shows that over a value of the cold expansion degree, we clearly notice a decrease of the time life and an increase of the crack propagation rate. In these cases the expansion becomes disadvantageous compared with a single drilling. In our case for both alloys we find the behaviour inversion for a expansion of 5.5%. The residual stresses and the plastic zone size were calculated from a numerical code (F.E.M IDEAS code in 3D). The results are given on the table 3. Residual stresses MPa Plastic Zone Size mm C.E.D 1.7% C.E.D 3.4% C.E.D4.3 % C.E.D 1.7% C.E.D 3.4% C.E.D4.3 % 60XX1 295 317 335 4.38 5.68 6.39 60XX2 310 340 360 3.80 5.02 5.05 TABLE 3: RESIDUAL STRESSES AND PLASTIC ZONE SIZE VERSUS COLD EXPANSION DEGREE The residual stresses act like a vice so the crack tip opening displacement is strongly dependents on the cold expansion degree. The results are given in three cases (table 4). We can notice a quasi stability in the absence of any expansion. In the presence of an expansion, the crack opening decreases in the first cycles of loading the a stability. Consequently, we can have a stresses redistribution during the first cycles. Crack tip opening displacement mm 1 cycle 50000 105 Fatigue crack 0.624 - - Radius 3 mm 0.318 0.318 0.290 Expansion 4.3% 0.211 0.162 0.165 TABLE 4 CRACK TIP OPENING DISPLACEMENT The Scanning Electron Microscopy shows the plastic deformation at the crack tip and into the zone near the crack tip we don’t notice any micro crack the residual compressive stresses and the plastic deformation resulting from cold expansion closed these ones. On the other hand, far from the crack tip into the initial structure we notice a lot of micro-crack. Near the crack Tip Far from the crack tip PHOTO 3: SCANNING ELECTRON MICROSCOPY OF FRACTURE

RkJQdWJsaXNoZXIy MjM0NDE=