In our previous work [1], it was clarified that the residual stress formed by the WPC process alone has a maximum value close to the surface and is stable under cyclic loading. Such residual stress effectively prevents propagation of small fatigue cracks. However, the ability to suppress crack propagation is limited in a very shallow depth beneath the surface, since the compressive residual stress layer formed by the WPC is very shallow. Thus, the WPC process has a problem in that the fatigue strength is not improved as much as it is expected from the effect of work hardening and of high compressive residual stress at the surface. To make the effect of WPC on fatigue strength of the steel more effectively, it is necessary to develop a new surface treatment technique in which compressive residual stress is distributed over a deeper layer, while keeping the features of the residual stress produced by WPC. In order to produce such residual stress distribution, it seems to be useful to combine WPC with other surface treatment method which can give a deeper compressive residual stress layer. In this study, we selected the carburizing process in combination with WPC. Attention was focussed on the distribution of residual stress and the effect of residual stress generated by the combined process on fatigue properties. 2. EXPERIMENTAL A low carbon Cr-Mo steel (JIS SCM420H) with a chemical composition as listed in Table 1 was used. A 20mm diameter steel bar was machined into shape, which is described in Figure 1, and then finished by electrochemical polishing. After the carburizing process, the WPC process was applied. Table 2 shows the process parameters used in this study. A Vickers microhardness tester was used to measure the microhardness of samples. X-ray diffraction equipment was used to examine the residual stress distribution in hardened layers. The fatigue tests were performed using a rotational bending fatigue testing machine (3000rpm) at room temperature in a laboratory environment. After the fatigue test, crack initiation sites were examined by using an optical microscope and a scanning electron microscope (SEM). Table.2 Condition of WPC and Shot Peening Table.1 Chemical Composition Fig. 1 Specimen configuration 3.RESULTS AND DISCUSSION 3.1 Characterization of hardened layer Figure 2 shows Vickers microhardness distributions on the cross section of the carburized specimen and
RkJQdWJsaXNoZXIy MjM0NDE=