of the mean stress as proposed by Matsumoto[2], an increase in fatigue strength of about as much as 500MPa could be expected due to the combined process. However, the result is not true for the present case, where the increase of fatigue strength is about 200MPa. In order to examine the cause, SEM observation of the fracture surface was performed with special attention to the fracture origin in both types of specimens. Figure 5 and 6 show the fracture surfaces of the specimen treated by the carburizing and the combined process, respectively. In the carburized specimens, a fatigue crack initiated at the surface of specimen leads to the final fracture. In the combined processed specimen, however, the final fracture was resulted from the fatigue crack initiated from the inside of the specimen. From the results mentioned above, it is clear that the surface modification due to the combined process is not effective for the improvement of the fatigue strength, because the fracture occurs inside the specimen without occurring in the surface modified layer as shown in Figure 6. Consequently, the small increase in fatigue strength due to the combined process can be attributed to the transition of the fracture mode from surface to internal one. 3.3 Fatigue tests of notched specimen In order to examine the effect of the surface modified layer generated by the combined process on fatigue properties, it is necessary to study the fatigue properties of the notched specimen in which the fatigue crack starts at the specimen surface. Additional fatigue tests were carried out using notched specimen with a stress concentration factor of α=2.3. The results are shown in Figure 7. In the case of notched specimens, the fatigue strength is remarkably improved by the combined process; the extent of improvement of fatigue strength for the notched specimen is much higher than that of the un-notched specimen. In this case, the fatigue crack started at Fig.6 Typical feature of fracture surface ( WPC after carburizing, σa=1050MPa, Nf=6.56×105 cycles) 500µm Fig.8 crack initiation site of notched specimen (WPC after carburizing, σa= 950MPa, Nf=3.6×10 4) 100µm Fig.7 Results of fatigue tests for notched specimen
RkJQdWJsaXNoZXIy MjM0NDE=