the surface (notch root, Figure 8). This implies that the high compressive residual stress generated by the combined process results in an improvement of fatigue strength. 3.4. Residual stress under cyclic loading In order to explain why the combined process is effective for the improvement of the fatigue strength of the notched specimen, the stability of residual stress within the surface modified layer was investigated. We measured the change in residual stress under cyclic loading. The results are shown in Figure 9, where the residual compressive residual stress remains unchanged after stress cycles n=105 in the specimen modified by the combined process. From the results, it could be concluded that the initiation and propagation of small surface crack can be suppressed by the compressive residual stress in the surface layer with a high hardness, resulting in a remarkable improvement of fatigue strength. Fig.9 Release behavior of residual stress (σa=950MPa) 4. CONCLUSION (1) By combining carburizing and the WPC process, it is possible to generate a high compressive residual stress near the surface, while keeping a deep compressive residual stress layer associated with the carburizing. (2) In the specimens modified by the combined process, compressive residual stress maintains a high-level at the surface after stress cycling. The compressive residual stress in the surface layer with a high hardness effectively suppresses initiation and propagation of small surface cracks, and remarkably improves the fatigue strength. (3) In the un-notched specimen where the stress gradient is gentle, the surface modified layer is not effective for the improvement of fatigue strength, because the fracture occurs from the inside of the specimen. In the notched specimens, however, the surface modifying effect for the improvement of the fatigue strength can act more effectively than in plain specimen, because the fatigue crack initiates at the specimen surface in notched specimen. References 1. D. Yonekura, J. Noda, J. Komotori, M. Shimizu, Y. Miyasaka, Advanced Materials Development & Performance, Procs. of 2nd Inter. Conf. on Advanced Materials Development, Performance Evaluation and Application, Tokushima, Japan, Vol.1,Tokushima,Japan,Nov.23-26, 1999, pp.64-67 2. .K. Matsumoto, T. Sanpei, T. Toyota, T. Kanazawa, Proc. '90 M&M Conf. JSME, No. 900-86,1990, pp.275-277
RkJQdWJsaXNoZXIy MjM0NDE=