NON PROPAGATING CRACKS A crack present in the connecting rod will remain stationary as long as the interval of the acting stress intensity factor, ∆K, is kept below the threshold level ∆Kth (taken as 7MPa√m for the steel in question [4]). For semielliptical surface cracks (Figure 2), ∆K can be calculated from [1] ∆K = ∆σ Q aπ fgh (3) x y z Figure 1: Finite element modeling of the connecting rod head. Figure 2: Geometric parameters of semielliptical cracks. where ∆σ is the stress interval and Q, f, g and h are functions of a, c, t and W, and are given elsewhere [1,5,6]. As shown in Figure 2, the crack depth and crack length are represented by a and 2c, respectively. The angle α defines the angular position of the point on the crack tip where ∆K is to be calculated and t refers to the thickness. For a surface crack, which lies in the highly stressed area along the line of closest approach between the circular holes (Figure 1), W was taken as 52mm, which corresponds to the distance of closest approach measured along that line. For a given crack depth a, one can determine the largest length such that the crack will not be able to propagate, a condition that is satisfied for ∆K = ∆Kth. Possible combinations of a and c for nonpropagating cracks can thus be obtained and are presented in Figure 3. An important conclusion that can be drawn from this figure refers to the strong influence of the crack depth on the maximum permissible length for values of a around 0.3mm.
RkJQdWJsaXNoZXIy MjM0NDE=