ICF10B

glass and hard metals(1)(2). This method is a relatively new process using a rigid metallic bond with the assistance of a special pulse electrolytic in-process method. The wheel is electrolytically dressed during the grinding process for continuous protruding abrasives from the grinding wheel. Until now, mirror surface machining of optical and electronic components mainly have been performed by polishing and lapping, but these methods provide poor machining accuracy and very low efficiency. Excellent smooth surfaces can be achieved by ELID with the use of extremely fine abrasives. To apply this process for bio-implant materials, it is very important to study the corrosion resistance of the materials finished by the ELID grinding process. However, few works(3)(4) have been published on corrosion of the ELID ground materials. In this study, corrosion resistance of a stainless steel having different surface characteristics was examined with special focus on the effect of surface roughness on corrosion response. 2. EXPERIMENTS 2.1 Materials and surface treatment The chemical composition of the material (type 316 stainless steel) used in this study is given in Table1. The configuration of the test specimen is shown in Fig.1. Prior to surface finishing, all the specimens were carefully degreased using acetone, and dried with hot air. The test specimens were then subjected to two surface finishing processes; (1) ground by the ELID grinding method, and (2) ground and polished by emery paper (400 to 2000 grit) and alumina suspension (0.3mm). The rotating speed of the wheel for ELID grinding was 100 rpm and applied pressure was 150kPa. Three types of cast iron diamond wheels were used with different sizes of abrasives (#325, #2000 and #8000 wheel). Fig.2 shows the construction of the proposed ELID grinding system. Fig.3 shows the schematic illustration of the ELIDgrinding mechanism in order to maintain ultraprecision finish grinding with fine abrasives. 2.2 Corrosion test Electrochemical corrosion tests were carried out using a three electrode electrochemical cell connected to a computer driven potentiostat. The potentials were referred to as a saturated calomel electrode (SCE). Approximately 500 Fig.1 Specimen configuration Table1 Chemical composition of type 316 stainless steel (wt%) Bal. 2.01 0.05 0.30 13.1 0.39 0.26 10.59 16.36 Fe Cr Mo Ni Si Mn P S C 7 10 ø16

RkJQdWJsaXNoZXIy MjM0NDE=