ORAL REFERENCE:ICF0328 EFFECT OF TEST RATE ON TENSILE STRENGTH OF VARIOUS CONTINUOUS FIBER-REINFORCED CERAMIC COMPOSITES AT ELEVATED TEMPERATURES S. R. Choi* and J. P. Gyekenyesi NASA Glenn Research Center, Cleveland, OH 44135, USA ABSTRACT Ultimate tensile strength of three continuous fiber-reinforced ceramic composites, including SiC/CAS-II, SiC/MAS-5 and SiC/SiC, was determined as a function of test rate in air at 1100 - 1200oC. All three composite materials exhibited a strong dependency of strength on test rate, similar to the behavior observed in many advanced monolithic ceramics at elevated temperatures. Both the applicability of the preloading technique and the excellent data fit to log (ultimate strength)-vs-log (test rate) relation suggested that the overall macroscopic failure mechanism of the composites would be the one governed by a power-law type of damage evolution/accumulation, analogous to slow crack growth commonly observed in advanced monolithic ceramics. KEY WORDS Continuous fiber-reinforced ceramic composites (CFCCs), ultimate tensile strength, elevated-temperature mechanical testing, loading rate dependency of ultimate strength, failure mechanism, preload technique, constant stress-rate testing INTRODUCTION The successful development and design of continuous fiber-reinforced ceramic composites (CFCCs) depends on a thorough understanding of basic properties such as fracture and delayed failure (slow crack growth, fatigue, or damage accumulation) behavior. In particular, accurate evaluation of delayed failure behavior under specified loading/environment conditions is a prerequisite to ensue accurate life prediction of structural components. This paper describes the effect of test (or loading) rate on elevated-temperature ultimate tensile strength of three different NicalonÔ fiber-reinforced ceramic composites such as SiCf/calcium-aluminosilicate (CAS), SiCf/magnesium-aluminosilicate (MAS) and SiCf/silicon-carbide (SiC) ceramic composites. For each composite material, strength was determined in air as a function of test rate at elevated temperature of 1100oC (for SiC/CAS and SiC/MAS) or 1200oC (for SiC/SiC). This type of testing, when used for monolithic ceramics, is called “constant stress-rate” or “dynamic fatigue” testing [1-3]. The loading rate dependency of strength was analyzed with the power-law damage or slow-crack-growth propagation, conventionally utilized for monolithic ceramics and glass. Preloading tests were conducted to better understand the governing failure mechanism(s) of the materials. It should be noted that few studies on the subject of loading rate dependency have been done for continuous fiber-reinforced ceramic composites [4], particularly at elevated temperatures. * NASA Senior Resident Research Scientist, Ohio Aerospace Institute, Cleveland, OH.
RkJQdWJsaXNoZXIy MjM0NDE=