ICF10B

needed. The results of this work also suggest that care must be exercised when characterizing elevatedtemperature strength of composite materials. This is due to the fact that elevated-temperature strength has a relative meaning if a material exhibits rate dependency: strength is simply dependent on which test rate one chooses (Figure 1). Therefore, at least two test rates (high and low) are generally recommended to better characterize high-temperature strength behavior of a composite material. CONCLUSIONS Elevated-temperature strength of three continuous fiber-reinforced ceramic composites, including SiC/CASII, SiC/MAS-5 and SiC/SiC, exhibited a strong dependency on test rate, similar to the behavior observed in many advanced monolithic ceramics at elevated temperatures. The applicability of the preloading technique as well as the reasonable data fit to log (ultimate strength)-vs-log (test rate) relation suggested that the distinct, overall failure mechanism of the composite materials would be a process primarily governed by a power-law type of damage evolution/accumulation, analogous to the mechanism observed in monolithic counterparts. Acknowledgements This work was in part supported by the UEET Program, NASA Glenn Research Center, Cleveland, Ohio. The authors are grateful to R. Pawlik for the experimental work during the course of this work. REFERENCES 1. Evans, A.G. (1974) Int. J. Fracture, 10 251. 2. ASTM C 1368, Annual Book of ASTM Standards, Vol. 15.01, American Society for Testing and Materials, West Conshohocken, PA (2000). 3. ASTM C 1465, Annual Book of ASTM Standards, Vol. 15.01, American Society for Testing and Materials, West Conshohocken, PA (2001). 4. Sorenson, B.F. and Holmes, J.W. (1996) J. Am. Ceram. Soc. 79 313. 5. Worthem, D.W. (1995) NASA CR 195441, NASA Glenn Research Center, Cleveland, Ohio 6. Choi, S.R. and Gyekenyesi, J.P. (2000) Proc. of the 7th Annual International Conference on Composite Materials, pp.299-300, Hui, D. (Ed), University of New Orleans, New Orleans. 7. Worthem, D.W. (1990) NASA CR 185261, NASA Glenn Research Center, Cleveland, OH (1990). 8. (a) Choi, S.R. and Gyekenyesi, J.P. (1997) ASME Trans., J. Eng. Gas Turbines & Power, 119 493; (b) Choi, S.R. and Salem, J.A. (1995) Ceram. Eng. Sci. Proc. 16[4] 87. 9. ASTM C 1359, Annual Book of ASTM Standards, Vol. 15.01, American Society for Testing and Materials, West Conshohocken, PA (2000). 10. Choi, S.R. and Gyekenyesi, J.P. (2001), to be published in Ceram. Eng. Sci. Eng. Proc. 22. 11. Curtin, W.C. and Halverson, H.G. (1999) HITEMP Review: Advanced High Temperature Engine Materials Technology Project, NASA/CP-1999-208915/VOL2, Paper 48, NASA Glenn Research Center, Cleveland, Ohio. 12. Lewinsohn, C.A., Henager, C.H. and Johns, R.H. (1998) Ceram. Eng. Sic. Proc. 19[4] 11. 13. Henager, C.H. and Jones, R.H. (1994) J. Am. Ceram. Soc. 77[9] 2381. 14. Spearing, S.M., Zok, F.W. and Evans, A.G. (1994) J. Am. Ceram. Soc. 77[2] 562.

RkJQdWJsaXNoZXIy MjM0NDE=