ORAL/POSTER REFERENCE: ICF100354-OR EFFECT OF THE NOTCH SHAPE AND THE PRESENCE OF A CIRCULAR VOID IN FRONT OF A CIRCULAR NOTCH ON THE FAILURE MODE TRANSITION SPEED IN AN IMPACT LOADED PLATE R. C. Batra, N. A. Jaber and M. E. Malsbury Department of Engineering Science and Mechanics, M.C. 0219 Virginia Polytechnic Institute and State University Blacksburg, VA 24061 USA ABSTRACT We study dynamic thermomechanical deformations of a prenotched plate impacted on the notched side by a cylindrical projectile of diameter equal to the distance between the notches, and made of the same microporous thermoviscoplastic material as the plate. For the ratio of the semimajor to the semiminor axes of the notch tip equal to 0.4, 1.0, 2.0 and 10.0, the impact speed at which the failure mode transitions from the brittle to the ductile is computed. For a circular notch-tip of radius r0 , we delineate the effect on the failure-mode initiation of the presence of a hole of radius r0 and situated directly ahead of the notch tip at distances of 3r0; 4ro; 5ro and 6ro . 1 INTRODUCTION Kalthoff (2000) and Kalthoff and Winker (1987) have experimentally studied dynamic deformations of a rectangular high strength steel plate containing two notches, with circular notch tips, parallel to the top edge of the plate and extending to the middle of the plate. They found that, with an increase in the impact speed, the failure mode changed from a brittle failure in the form of a crack propagating at about 70 to the notch-axis to a ductile failure in the form of a shear band emanating essentially parallel to the axis of the notch. The failure mode transition speed was found to depend upon the notch tip radius r0 . Needleman and Tvergaard (1995), Zhou et al. (1996), Batra and Nechitailo (1997), Batra and Gummalla (2000), Batra and Ravisankar (2000) and Batra and Jaber (2001) have numerically studied the problem. Whereas Batra and Ravisankar analyzed the three-dimensional problem, other investigations scrutinized plane strain deformations of the plate. These works employed different thermoviscoplastic relations and obtained qualitatively similar results. The maximum principal tensile stress was found to occur at a point a little above the upper surface of the notch tip, and the shear band initiated from a point on the lower surface of the notch tip, which is closer to the impacted surface of the plate. Only Batra and Jaber (2001) computed the failure mode transition speed and found it to depend upon the thermoviscoplastic relation employed to characterize the material response. Here we explore the effect on the failure mode transition speed of the notch tip shape and the presence of a circular hole ahead of a circular notch tip. 2 FORMULATION OF THE PROBLEM A schematic sketch of the problem studied is shown in Fig. 1. A rectangular plate with two parallel notches extending nearly to the vertical centroidal axis is struck at normal incidence on the notched side by a cylindrical projectile made of the same material as the plate. The diameter of the projectile equals the distance between the
RkJQdWJsaXNoZXIy MjM0NDE=