0 100 200 300 400 500 500 1000 1500 2000 SA516-Gr.70 steel 0.3 mm/min 10 mm/min 1000 mm/min solid:Mat. A, open:Mat. B J0.1 (kJ/m2) Temperature(C) o As the loading rate increased, the temperature at which the fracture resistance became minimum or each loading rate shifted to higher temperature region. On the basis of previous research, the occurrence of the abrupt drop in J-R fracture resistance at a specific temperature and loading rate range is due to DSA [2]. In case of Mat. B, the temperature range which DSA occurred in was shifted to a higher temperature region and was narrower compared to Mat. A. DSA phenomena was usually recognized by serrated flows in tensile stress-strain curve that is referred to Portevin-Le Chatelier effect [5]. Fig. 4 shows tensile test results for SA516-Gr.70 steels. The serrated flows were obviously observed in some test conditions. The serrations in Mat.A was more apparent than those in Mat.B. The conditions for the occurrence of serrated flows were expressed as a serration map in Fig. 5. Fig. 3 : Variation of J0.1 at various temperature Since DSA is regarded as a thermally activated process, and loading rate. the activation energies of solute diffusion in test materi als can be obtained from Arrhenius type plot. (a) (b) 200 300 400 500 600 700 SA516-Gr.70 steel Mat.A, 177oC ε=8.3x10-2s-1 ε=4.2x10-2s-1 ε=8.3x10-3s-1 ε=8.3x10-4s-1 ε=8.3x10-5s-1 ε=2.5x10-5s-1 Stress (MPa) Strain Fig. 4 : Stress-strain curves at various strain rates for (a) Mat.A and (b) Mat.B. 200 300 400 500 600 700 SA516-Gr.70 steel Mat.B, 230oC ε=4.2x10-2s-1 ε=2.5x10-2s-1 ε=8.3x10-3s-1 ε=2.5x10-3s-1 ε=1.7x10-3s-1 Stress (MPa) Strain The activation energies were determined as 65 and 92 kJ/mol for Mat.A and Mat. B respectively as represented in Fig. 5. The differences of fracture resistance and DSA behaviors between two heats of SA516-Gr.70 steels were analyzed with respect to chemical composition and microstructural factors. It was found that the comparatively high fracture resistance of Mat. B under all test conditions due to smaller grain size and lower pearlite to ferrite ratio compared to Mat. A. The concentrations of interstitials and activation energy for diffusion are main factors that affect on DSA behavior in steel [6]. The concentrations of carbon - 4 -
RkJQdWJsaXNoZXIy MjM0NDE=