ICF10B

propagation. Crack propagation is strongly affected by plastic deformation at the crack tip and the typical plastic deformation of polymethyl methacrylate (PMMA) is crazing. In our previous study, the vicinity of a crack tip, which was growing in PMMA, was observed in detail using a scanning laser microscope. It was found that the crack usually accompanied a craze and bright bands, which were made of broken craze, were remained along the crack wakes under monotonic loading conditions. Fracture surfaces were even in this case. However, these bands were not observed under cyclic loading condition but successive ridges were sometimes observed along the crack wakes. Striations corresponded with the valleys between these successive ridges. These results suggest that striations were made by contacts between surfaces during unloading, in other words, closure produces striations on fatigue fracture surfaces of PMMA. To clarify the effects of closure on striation formation in PMMA, fatigue tests were performed with changing stress ratio. A confocal scanning laser microscope was used to observe in-situ fatigue crack propagation in compact type (CT) specimens. These observations clarify the state of the crack wakes in PMMA at each stress ratio. Moreover, to clarify the effects of R-ratio on striation formation, fatigue fracture surfaces were observed using FE-SEM. According to all the results, both of a striation formation mechanism and a crack propagation mechanism on PMMA are discussed. MATERIAL AND EXPERIMENTAL PROCEDURES Material The material used in this study was a commercial acrylic cast sheet, 15 mm in thickness, Sumipex supplied by Sumitomo Chemical Co., LTD. Compact type (CT) specimens with dimensions shown in Figure 1(a) were cut from this sheet. 19 15 (mm) Figure 1: A schematic diagram of a compact type(CT) specimen 41 59 The specimens were heat-treated in an oven at a temperature of 363 K for 24 hours to dry and remove any

RkJQdWJsaXNoZXIy MjM0NDE=