ORAL REF: ICF100191OR EFFECTS OF STRESS RATIO ON STRIATION FORMATION UNDER CYCLIC LOADING CONDITIONS IN POLYMETHYL METHACRYLATE (PMMA) C. Ishiyama*, M. Kobayashi, T. Asai and Y. Higo Precision and Intelligence Laboratory, Tokyo Institute of Technology, 4259 nagatsuta-cho, Midori-ku, Yokohama, Kanagawa, JAPAN ABSTRACT The fatigue crack propagation tests were performed on an amorphous polymer, poly (methyl methacrylate) (PMMA) to investigate the striation formation mechanisms. A confocal scanning laser microscope was used to observe in-situ crack propagation in compact type (CT) specimens under tensile-tensile fatigue loading conditions. Fatigue cracks usually propagated within the craze which always existed at the crack tip at a relative humidity of 75% and an R-ratio of 0.1-0.5. Craze fragments were observed at the edges of the crack at the maximum load of a loading cycle. However, they disappeared in the subsequent cycle at the R- ratios. This may be because a part of the broken fibrils, which were situated just behind the crack tip, were pushed down by the contact between the fracture surfaces during unloading. This may mark fracture surfaces with striations. However, broken crazes did not disappeared in the subsequence cycle at an R ratio of 0.7. After these tests, fatigue fracture surfaces were observed using a field emission-gun scanning electron microscope (FE-SEM). With increasing R-ratio, striations become less obvious. These results support the contact model for striation formation. According to these results, a striation formation mechanism on PMMA is discussed. KEYWORDS striations, polymethyl methacrylate (PMMA), fatigue crack growth, stress ratio INTRODUCTION Recently many researchers have been studying crack propagation behavior of glassy polymers under static loading conditions [6, 12] or cyclic loading conditions [2, 3, 9-11] to clarify the mechanisms of crack
RkJQdWJsaXNoZXIy MjM0NDE=