ICF10B

RESULTS Tensile and Creep tests The tensile and creep data determined at 700°C on materials as cast + HIPed (As Cast), and HIPed + heat-treated at 1300°C (HT 1300°C) are given in Table 1. The reported tensile data is an average value of two tests, which had a marginal scatter. The creep exponents reported in Table 1 are average values for the entire data set for a material condition. TABLE 1: TENSILE AND CREEP DATA OF TiAlCr AT 700°C Material Rp0.2 (MPa) Rm (MPa) E-Modulus (MPa) A5 (%) D1 m n As Cast 372 522 152 450 0,03 8,0E-5 6,56 7,78 HT 1300°C 326 412 152 000 0,34 7,0E-5 9,13 9,19 Creep Crack Growth Tests The scatter and pop-ins in recorded experimental data may be related to the mixed fracture mode with secondary cracking and crack front tunneling. The crack tip deformation and crack extension studied in a SEM on sectioned specimens. The complete set of creep crack growth data obtained from CT specimens of both As Cast and HT 1300°C materials at 700°C are correlated with crack tip parameters K and C*(t) in Figures 1 and 2, respectively. Fig.1.Crack growth rate as a function of K at 600°C (complete set of data). 1E-04 1E-03 1E-02 1E-01 15 25 35 45 55 65 75 K (MPam0.5) da/dt (mm/h) V rate: 5um/h V rate=10um/h Fconst=10kN V rate: 1; 5 & 10um/h 1E-04 1E-03 1E-02 1E-01 1E-02 1E-01 1E+00 1E+01 C*(t) (N/mm/h) da/dt (mm/h) V rate: 5um/h V rate=10um/h Fconst=10kN V rate: 1; 5 & 10um/h Fig.2.Crack growth rate as a function of C*(t) (complete set of data). The CCG rate data correlated with K are reduced to transition range, i.e. ∆a<0.2mm, showing a good correlation, as depicted in Figure 3. On the other hand, the crack growth data from displacement rate controlled tests (Vrate in Fig.2) showed decreasing C*(t) due to crack growth rate effect beyond Fmax. This data is reduced up to Fmax in Figure 4, which gives a linear crack growth correlation. The data from constant load test, however, shows two parts that calls for study of effects of sharp starter crack and loading mode in CCG testing and validity of crack growth data. Therefore, the crack growth data is further analysed comparing the data from constant load and displacement rate control tests in Figures 5 and 6, respectively. Both tests showed the ratio of creep component of displacement rate, V , to total displacement rate, , >0.9 for the whole range of tests (Figs.5 a and b), satisfying the validity requirement of the test standard [11]. However, the rather brittle fracture mode observed in SEM calls for c & tV& cV /V & & t

RkJQdWJsaXNoZXIy MjM0NDE=