ICF10B

1E-03 1E-02 1E-01 15 25 35 45 55 65 K (MPam0.5) da/dt (mm/h) V rate: 5um/h V rate=10um/h Fconst=10kN V rate: 1; 5 & 10um/h da/dt = 0,0099 C*(t) 0,6937 1E-04 1E-03 1E-02 1E-01 1E-02 1E-01 1E+00 1E+01 C*(t) (N/mm/h) da/dt (mm/h) V rate: 5um/h V rate=10um/h Fconst=10kN V rate: 1; 5 & Fig.3. Crack growth rate as a function of K (reduced data for ∆a<0.2mm). Fig.4. Crack growth rate as a function of C*(t) at 600°C (reduced data for F<Fmax). analysis of deformation and deflection rate partitioning. The total load line deflection, Vt, together with elastic, Ve, and creep components of deflection, Vc, are shown in Figure 6 a and b, for constant load and displacement rate control tests as a function of normalised time, t/tf, respectively. A difference in the growth of creep deformation is noted from the variation of creep component of deflection, Vc, in the figures. b) 0,86 0,88 0,90 0,92 0,94 0,96 0,98 1,00 0,0 1,0 2,0 3,0 Crack Extension ∆a (mm) Fmax 1µm/h V=5µm/h V=10µm/h c t V V & & a) 0,86 0,88 0,90 0,92 0,94 0,96 0,98 1,00 0 1 2 3 4 5 Crack Extension ∆a (mm) da/dt & C*(t) min. c t V V & & Fig.5.Ratio of load-line deflection rate due to creep (dVc/dt) to total load-line deflection rate (dVt/dt) as a function of crack extension (∆a) for HT1300°C TiAlCr tested at 700°C a) under constant load, b) displacement rate control. DISCUSSION The microstructure, particularly lamellar grain size and orientation, affects the fatigue crack initiation and fatigue crack growth leading to multi-crack initiation and crack branching [7], mainly affected by the lamellar orientation at the crack tip. The FCP load calculated from formulas given in the test procedures [11,12] overestimate the precrack loads by a factor of three. The difficulty faced with introduction of sharp starter crack may be overcome by spark erosion (EDM) of a fine, i.e. tip radius ρ<0.05mm [8], starter slit notch. The crack growth monitored during testing CT specimens using the DCPD method.

RkJQdWJsaXNoZXIy MjM0NDE=