ICF10B

POSTER REFERENCE:ICF100119PR ERROR ESTIMATION OF SHAPE CHANGES DURING FATIGUE CRACK GROWTH T. D. Righiniotis1 1 Department of Civil and Environmental Engineering, Imperial College, London, SW7 2BU, UK ABSTRACT Accurate determination of the shape of a crack is important during fatigue. On the other hand, simulation may require a considerable number of fatigue evaluations that correspond to a wide range of crack shapes. Therefore, the numerical methods employed to carry out this task need to address the issues of accuracy, robustness and efficiency. In this paper, a fourth order Runge-Kutta scheme is used for crack shape evaluation and its accuracy is first assessed by comparison to closed form solutions for a surface cracked plate under tension and by means of a convergence study for the surface-cracked butt welded plate in tension. Finally, a convergence study is carried out on the fatigue lives of Monte Carlo samples of the latter geometry. This last study is carried out by assuming that crack growth follows a bi-linear law. KEYWORDS Semi-elliptical surface crack, fatigue, shape changes, Monte Carlo simulation INTRODUCTION Under fatigue, cracks grow while retaining a semi-elliptical shape. Accurate determination of the crack shape is important at all times during the crack evolution since accurate stress intensity factor determination and hence rate of crack growth is heavily reliant on the dimensions of the crack. For a two degree-of-freedom surface crack, and assuming that the Paris C parameters are the same in both directions [1], the pertinent equations are:

RkJQdWJsaXNoZXIy MjM0NDE=