POSTER REFERENCE: ICF100287PR ESTIMATION OF DYNAMIC STRESS INTENSITY FACTORS FOR BEAM AND CYLINDRICAL SPECIMENS S. Ye. Kovchyk1, V. M. Boyko1, I. V. Khodan1, I. D. Skrypnyk2 1 Karpenko Physico-Mechanical Institute, National Academy of Sciences of Ukraine, 5, Naukova st., 79601, Lviv, Ukraine 2 Faculty of Design, Engineering and Production, Delft University of Technology 9, Jaffalaan, NL-2628 BX, Delft, the Netherlands ABSTRACT A simple numeric-experimental method for estimation of dynamic stress intensity factors (DSIF) at impact tests of cylindrical and beam specimens is proposed. For the case of solid cylindrical specimen the formulas are derived for estimation of DSIF from tensile impact tests (KI) and impact torsion (KIII), while for a hollow cylindrical specimen only tensile impact tests are used (KI). For the beam specimens symmetrical and eccentric three-point bending loading schemes are considered. The formulas derived contain parameters, estimated from modal analysis. They were evaluated using commercial Finite Element Analysis (FEA) package MARC. Based on the obtained numerical data and using the least square method, simple relations are derived for these parameters. These relations account also for some geometric parameters of specimens considered. For use of these formulas the experimental loading diagram “applied force – time” is necessary. Therefore, special testing equipment was developed for every type of loading and type of specimen (named above). In order to verify the proposed formulas, the values of DSIF are estimated numerically using FEA package MARC and Newmark incremental integration method for all the cases considered. Good correlation between the results obtained numerically and based on proposed formulas is observed. KEYWORDS Impact test, modal analysis, experimental loading diagram, finite element analysis. INTRODUCTION Until recently the dynamic problems of fracture mechanics were studied only for idealized cases (for instance for infinite solid). Nowadays, using advanced numerical methods (namely, FE method [1, 2]) it became possible to find a solution to the dynamic problems for solid with more real shape. For evaluation of dynamic stress intensity factors (SIF) one can use also experimental approach. One way is to use a small-spacing strain gage. However, the drawback of this approach is a necessity to glue every strain gage to the specimen with following calibration. Another way consists in use of the photoelasticity method. This method requires high-speed photography and, hence, is very cumbersome and is used only in for calibration.
RkJQdWJsaXNoZXIy MjM0NDE=