On the other hand, the stress intensity factor of surface crack type was calculated from Eqn.4 [8]. KIsurf surf area = 0 65 . σ π [MPa ] (4) =C ( , m ⋅ surf surf a b) σ Here, the “area” is the fatigue crack area which is depended on the half crack length “a” and crack radius “b”. The values of the coefficient Cin of Eqn.3 is smaller than Csurf of Eqn.4, when the crack radius “a” of Eqn.3 and the one of Eqn.4 are the same, and 2a and 2b are the same also. M. Larsson et al [9] indicated that the fatigue limit of internal crack is explained by using the threshold of the stress intensity factor. In short, fatigue crack propagates when the stress intensity factor at crack tip reaches the threshold of the material. Here, because the threshold stress intensity factor does not vary with location in the specimen, the relationship between σin and σsurf is indicated as next equation. (5) ( ) σ = surf in Csurf Cin ×σ There is two consideration points in this Eqn.5. One is that the local fatigue limit inside the specimen is Csurf/Cin times as the local fatigue limit at surface. And the other is that the coefficient ratio Csurf/Cin depends on the depth of the crack position and the local fatigue limit is dependent on the depth from surface. Figure 7 shows relationship between the coefficient ratio Csurf/Cin and the depth from the surface. Estimated local fatigue limit distribution can be modified by this value. 0 0.2 0.4 0.6 0.8 1.0 1.0 1.2 1.4 1.6 1.8 2.0 Depth from surface d ,mm Value of Csurf/Cin Figure 7: Relationship between coefficient ratio Csurf/Cin and depth from surface 0 0.2 0.4 0.6 0.8 1 0 200 400 600 800 Depth from surface d , mm Stress σ , MPa HSP local fatigue limit Estimated fatigue limit 385MPa (modified) Modified of Figure 5 Figure 8: Modified local fatigue strength distribution inside the HSP treated specimen (using Endurance limit diagram)
RkJQdWJsaXNoZXIy MjM0NDE=