ICF10B

1. The inside layer was eliminated from load supporting member in structural design. 2. It was supposed that only compressive load acts on the section in service. Figure 2 shows a fracture surface of the broken cast steel bridge pier. It is recognized that there were some large shrinkage cavities which played a role of the brittle fracture generating point in the bridge pier. Maximum depth and breadth of the shrinkage cavity were 18.8mm and 37.1mm respectively. To investigate the brittle fracture strength of this pier, this surface shaped defect was replaced by two dimensional infinite cracked body subjected to remote tensile stress, which the maximum value of stress intensity factor along the contour of the surface defect is equal [3]. The half crack length of one is equal to 18.3mm. Figure 2 Fracture surface of the broken cast steel bridge pier FRACTURE TOUGHNESS CHARACTERISTIC CURVE Fracture toughness characteristic curve of the broken cast steel bridge pier must be prepared to evaluate the brittle fracture accident. This curve represents the relationship between Rγ and fracture toughness. Fracture toughness tests under three loading speed (0.01, 1, 100mm/s) and four ambient tempreature (0, -20, -40, -60˚C) had carried out to identfy the characteristic curve. Calculation procedure for Rγ is stated in ref.[1]. 4000 6000 8000 10−3 10−2 10−1 100 101 : 0.01 mm/s : 1 mm/s : 100 mm/s Strain rate−temperature parameter in fracture process zone [K] Critical CTOD [mm] t = 46.4 (mm) open mark : ignoring temperature rise solid mark : considering temperature rise value in parentheses shows the amount of temperature rise crosshead speed (57.7) (40.4) (36.0) (10.8) (6.4) (41.0) σY0 = 383 (MPa) (21.9) (6.0) (6.4) (3.0) (1.1) Figure 3 Relationship between Rparameter in fracture process zone and critical CTOD Figure 3 shows the characteristic curve of the broken steel material. Figures in parentheses in Fig. 3 indicate the estimated value of temperature rise (unit in degree) due to plastic work at the tip of IDNZ. Rγ in Fig. 3 were acquired by adding this temperature rise to the ambient temperature of fracture toughness test condition. It makes clear that fracture toughness can be recognized as the function of Rγ over the wide loading speed and temperature conditions by considering the temperature rise due to

RkJQdWJsaXNoZXIy MjM0NDE=