ICF10B

the quantitative evaluation method of strain rate effect on fracture toughness is explained to the next section. Refer to ref.[1] for more precise information concerning this procedure. BASIC CONCEPT FOR THE QUANTITATIVE EVALUATION METHOD OF STRAIN RATE EFFECT ON FRACTURE TOUGHNESS Yield stress of steel materials can be represented only by R parameter, because yield stress increases with the temperature drop and with the strain rate rise. Rvalue under dynamic loading condition plays the same role as temperature under static loading condition for the constitutive equation of steels. Postulating the constitutive equation of materials followed by the n-th power work hardening (σ =Fεn), it was also confirmed that strain hardening exponent (n) depends only on yield stress in case of static condition. Static loading in our researches was defined as the condition that no strain rate effect appeares in the constitutive equation and the value is equal to 5.0×10−5s−1 [1]. Constitutive relation of steels under arbitrary strain rates, therefore, can be estimated only by the yield stress obtained fromRvalue although Rvalue usually changes throughout a loading process. 0.01 0.1 1 10 3000 4000 5000 6000 Distance from crack tip [mm] Strain rate−temperature parameter : R [K] IDNZ Crosshead speed : 2000 [mm/s] Test temperature : −22 [℃] load point displacement : 1.07 [mm] Figure 1 An example of Rparameter distribution in the vicinity of a crack tip Authors had presumed that fracture toughness is a function of R parameter under dynamic loading, because the fracture toughness is a function of temperature under static loading and R parameter performs a equivalent role of temperature under dynamic loading. Besides, R parameter considered the temperature rise generating by plastic work takes almost constant value in the fracture process zone at an arbitrary moment as shown in Fig. 1 [1] for example. This flat distribution could be appear as the additive effects obtained by combining temperature rise due to plastic work with strain rate distribution in the vicinity of a crack tip. In this figure, IDNZ defined by Rice and Johnson [4] corresponds to fracture process zone. This phenomenon and the hypothesis which fracture toughness is a function of Rparameter enable to ignore identifying the precise fracture initiation point for evaluating strain rate effect on fracture toughness. R parameter which keeps almost constant value in fracture process zone denotes Rγ as follows. It can be recognized that fracture toughness is a function of Rγ under dynamic condition. Postulating that the relationship between Rγ and fracture toughness is the inherent characteristic of materials, fracture toughness under arbitrary strain rates can be quantitatively estimated from the results of static fracture toughness tests. GENERAL ASPECT OF THE BROKEN CAST STEEL BRIDGE PIER Some defects like shrinkage cavity existed in the inside layer of the broken cast steel bridge pier. These defects remained in service of this railway for the following reasons 1 and 2.

RkJQdWJsaXNoZXIy MjM0NDE=