POSSIBILITY OF BRITTLE FRACTURE GENERATED BY HORIZONTAL SEISMIC WAVE Brittle fracture genreating loads caused by horizontal seismic wave were estimated by inputting one pulse, which time duration equals 0.3s, to the FE model shown in Fig. 3. Supposed pulse time duration was almost equal to the average of observed time duration of horizontal seismic wave (north to south direction), which was equal to 034s, at the earthquake. Ambient temperature for the calculations was 4˚Cwhich was the same temperature at the day of earthquake. 0 50 100 150 1500 2000 2500 3000 Peak horizontal displacement at the top of bridge pier : up [cm] Horizontal load : PH [kN] (2176) (2297) (2350) (2371) (2394) (4506) (4200) (4000) (3910) (4572) (4609) (4629) pulse duration time : 0.3 [s] Value in paren. shows the horizontal acceleration at the top of the bridge pier [cm/s2] : initial yielding load of the reference : brittle fracture initiation load [ Pc ] : general yielding load of the reference : peak load corresponded to up [ PH ] (4670) 400 ~ cross section [ PYi ] cross section [ PYg ] Symbols yield stress (static) : 258 [MPa] equivalent crack length : 18.3 [mm] [Note] Figure 5 Estimation of brittle fracture generating load caused by horizontal seismic wave Figure 5 shows the calculation results. Solid triangle marks represent the relationship between brittle fracture generating load and horizontal displacement at the pier top. Open circle marks represent the initial yielding load of the reference cross section and open square marks represent the genreal yielding load on the same section. Diamond shape marks mean the peak load in case of no defect. Figures in parentheses are equal to the horizontal acceleration of the pier top (unit in cm/s2) at the each state. These result indicate that the brittle fracture accidents could be generated in case that the acceleration reached at least 4000cm/s2 and horizontal displacement of the pier top must exceed more than 40cm. Considering the observed maximum seismic wave acceleration of horizontal component equals 812.8cm/s2, it makes clear that the brittle fracture accident could not be generated by horizontal seismic wave. POSSIBILITY OF BRITTLE FRACTURE GENERATED BY VERTICAL SEISMIC WAVE To investigate the possibility of the brittle fracture accident generated by vertical component of the seismic wave, following analyses were carried out. 1. Time history response analyses of the bridge pier by applying the observed vertical seismic wave (maximum acceleration was equal to 333.3cm/s2). 2. Estimating the maximum amplitude of strain on the average of the reference cross section. 3. Calculation of time history of the relationship between R parameter in fracture process zone (Rγ) and CTOD by applying the half vertical pulse wave stated above. Solid circle marks in Fig. 6 show this time history. Bold curve in Fig. 6 represents the fracture toughness characteristic curve of the bridge pier material, which is shown in Fig. 3. Cross point of the bold curve and the time history indicates the unstable fracture generating. This result implys that it was impossible to generate the brittle fracture accident by acting the observed vertical seismic wave to the bridge pier directly.
RkJQdWJsaXNoZXIy MjM0NDE=