ICF10B

3000 5000 7000 9000 10−4 10−3 10−2 10−1 100 101 SMK520 Strain rate−temperature parameter : Rγ [K] Crack tip opening displacement : δ [mm] Plate tickness : 46.4 [mm] Yield stress(static) : 258 [MPa] T = 4.0 [℃] a = 18.3 [mm] − Amplification factor : α : α = 1.0 : α = 5.0 Fracture toughness characteristic curve of broken pier material Open mark : After general yielding Solid mark : Before general yielding Figure 6 Estimation of brittle fracture caused by vertical seismic wave Sonoda et al. [6] showed that the inputted vertical component of stress wave to the structures was amplified. The amplification factor (α) depends on the pulse period and velocity of the vertical seismic wave and the ratio of seismic wave acting area between ground and the bridge pier. Value of the amplification factor in case of our hilighted analysis condition (time duration equals 0.3s) was approximate to five [6]. Triangle marks in Fig. 6 show the R parameter in fracture process zone versus CTOD curve in case which the input vertical seismic wave was amplified to five times. Open marks of the triangle represent that the reference cross section reaches the general yielding condition. By considering the following conditions (a) through (c), the brittle fracture accident caused by the vertical seismic wave could be understood as a natural phenomenon. (a) Fracture toughness has a certain scattering. (b) The fracture toughness characteristic curve of the bridge pier material corresponds to the average curve of one. (c) Some specialists in seismology insisted that the stronger vertical short periodic pulse than the observed one could not be recorded because of the low ability of the recorders. CONCLUDING REMARKS Brittle fracture accident of centrifugal cast steel bridge pier at the Hyogo-ken Nanbu Earthquake was investigated by considering the strain rate effect on fracture toughness. The result makes clear that vertical impulsive seismic wave is the major source to generate the brittle fracture accident on this bridge pier. REFERENCE [1] Toyosada,M. and Gotoh,K. (1996) Memo. Eng. Kyushu University, 56, 273 [2] Bennet,P.E. and Sinclar,G.M. (1966) ASME J. Basic Eng. 88, 2, 518 [3] The Japan Welding Engineering Society Standard 2805 (1994) [4] Rice,J.R. and Johnson,M.A. (1970) Inelastic Behavior of Solids, McGraw-Hill, New York, 641 [5] Etou,O., Mihara,T. and Miki,C. (1998) J. Japan Soc. Civil Eng., 591/I-43, 236 [6] Sonoda,K., Kobayashi,S. and Fukui,A. (1997) Memo. Eng. Osaka City University, Jan., 169

RkJQdWJsaXNoZXIy MjM0NDE=