the following law of fatigue crack growth rate [16-19] in case of steels is satisfied for R = −1, where R is a stress ratio. d` dN =C3³ σa σB ´ n ` (2) Here, n and C3 can be estimated from a database if the heat treatment and steel type are known. Although there is a lot of fatigue data for steels, non ferrous materials have a few data. This is one obstacle to wide usage of new materials in mechanical engineering. Therefore in this paper, a fatigue crack growth rate law will be proposed from the fatigue crack growth mechanism and a few fatigue data. The mode I type of fatigue crack growth is based on the successive plastic blunting and resharpening of the crack tip. Then at first, in a non-work-hardening materials, crack growth due to the plastic blunting under a monotonic stress σ is obtained from the dimensional analysis as follows. ∆a ∝ σS E f³ σ σS ´a (3) Here, E is Young’s modulus, a the half crack length, and ∆a the increment of a. The crack growth due to plastic blunting is expressed concretely from CTOD with the Dugdale Model as follows. ∆a ∝ 8σS πE lnh sec³ πσ 2σS ´i a (4) It is supposed that the crack behavior due to the cyclic stress strain relation or load history can be represented by σS for steels. Although the differences of these factors among the materials are very important in the fatigue life near the non-propagating crack limit, the differences may be the secondary factor in Nf < 10 6 region. Hence the differences are neglected in this report. Therefore considering Eqn.2, the fatigue crack growth law is presented as follows, by approximating ln[sec(π/2×σ/σS)] with (σ/σS) n. d` dN =C4 σS E ³ σa σS ´ n ` (5) Figures 1 and 2 showC4 and n values in Eqn.5 obtained from small crack growth data of steels [15], aluminum cast alloy [4,20], rolled aluminum alloy [18], brass [21] and titanum alloy [22]. In steels whose mechanical properties are dependent on the alloy element and heat treatment, n and C4 in Eqn.5 should be functions of σS, however for simple use, n is taken to be constant; n= 6 in this paper. d` dN =C5 σS E ³ σa σS ´ 6 ` (6) Figure 3 shows C5 values of Eqn.6 obtained from Figs.1 and 2. The following expression is a curve through the center of the data. C5 =( σS 2500 (σS ≥300MPa) ( σS 510 ) 4 (σS <300MPa) (7) Even if materials are changed, most data lie between twice and half of Eqn.7 except for low carbon steels. C4 σS [MPa] Figure.1: Relation between C4 and σS n σS [MPa] Figure.2: Relation between n and σS C5 σS [MPa] Figure.3: Relation between C5 and σS
RkJQdWJsaXNoZXIy MjM0NDE=