OLAL/POSTER REFERENCE: ICF100930OR EVALUATION OF THERMAL AND ELASTIC PROPERTIES FOR SOLID SURFACES USING TRANSIENT REFLECTING GRATING METHOD K. Katayama 1, Q. Shen 2, A. Harata 3, and T. Sawada 1 1 Department of Advanced Materials Science, Graduate School of Frontier Sciences, The University of Tokyo, Tokyo 113-0033, Japan 2 Graduate School of Electro-Communications, The University of Electro-Communications, Tokyo 182-0021, Japan 3 Graduate School of Engineering Sciences, Kyushu University, 6-1 Fukuoka, 816-8580, Japan ABSTRACT Subnanosecond time-resolved transient reflecting grating (TRG) method has been developed and applied to various solid surfaces such as a DLC film on a multiplayer substrate and an Ar ion-implanted silicon. This method provides a depth profiling of thermal and acoustic properties by changing the observed depth which can be experimentally controlled, and has the least depth region of hundreds of nanometers. We propose a new microscopic method using the TRG method where the signal is measured at various delay times while scanning a sample. This gave a various kinds of images including thermal and elastic properties at local places in the surface and subsurface region. Further, for clarifying a fundamental mechanism of a heat generation, the TRG method has been improved to have a time resolution of hundreds of femtoseconds. In this time range, ultrafast carrier dynamics can be monitored and the energy transfer processes from carriers to phonons were detected clearly. INTRODUCTION Surfaces and subsurfaces of materials modified by means of ion implantation, chemical and physical vapor deposition, etc., sometimes show higher order structures such as gradient structures and multilayered structures. Their evaluation places some technical requirements on the measurement method being applied in manufacturing process, i.e., it should be noncontact, nondestructive, and in situ. Photothermal and related techniques can partially cover the requirements1 and deduce thermal and elastic properties for thin films, multilayered films and surface-modified materials. In the latest device technology, device components get smaller and smaller to the size region of nanometers, and for example, thin films of several nanometers in thickness are practically used. Conventional photothermal methods cannot measure thermal or elastic properties for such thin films of nanometer thickness because the methods usually have the least depth resolution of several micrometers. Thus, measurement methods for evaluating thin films of nanometer thickness are required. On the other hand, as the device size is reduced, the time of carrier transport between components also gets faster and faster to the time region of picoseconds. Ultrafast carrier transport generates heat in the nano-sized region, so that there are some local places with high temperature. To improve device
RkJQdWJsaXNoZXIy MjM0NDE=