ICF10B

The height difference between two points of the object was determined for the case of orthogonal projection by the formula Θ ∆ ∆ = 2 sin M F h , where ∆F is the difference of distances between the images of two points of the object on two microfractograms of the stereo pair. In view of an appreciable nonuniformity of the stretch zone height along the crack front its size was obtained by averaging the results of measurement of no less than four profiles of fracture surfaces for each specimen. It was established that even the appearance of two maxima recorded on the load vs displacement diagram does not imply the crack propagation since in this case the height of the stretch zone is mm and no crack propagation is observed on the fractograms of fracture surfaces. After the appearance of the first local maximum, the height of the relief does not change at all as compared to the initial fatigue crack. 2 5 10− × The action of the ECP results in an appreciable (1.4 fold) increase in the height of the stretch zone. The fact that there are no local maxima on the P-V diagram is likely to point to the change in the mechanism of its formation. CONCLUSION The investigations performed allow us to conclude that, when calculating the stress intensity factor in the case of discontinuous yielding of the material at a temperature of 4.2 K, the magnitude of the design load PQ should be determined either from the load maximum, which coincides with the 5% secant, or from that immediately following the latter. On exposure to the action of the ECP, this should be done from the first maximum. The ECP contributes to the intensification of the process of the plastic zone formation at the crack tip. This makes the plastic zone reach its critical size at lower levels of the load, i.e., the ECP acts as an embrittling factor. REFERENCES 1. Strizhalo V.A., Novogrudskii L.S., and Vorob’yov Ye.V. (1990). Strength of Materials Used in Cryogenic Engineering under the Action of Electromagnetic Effects (in Russian), Naukova Dumka, Kiev. 2. ASTM E399-74 (1975). Test Method for Plane Strain Fracture Toughness of Metallic Materials. Annual Book of Standards, Philadelphia, USA. 3. GOST 25506-85 (1986). Methods of Mechanical Testing of Metals. Determination of the Characteristics of Crack Growth Resistance (Fracture Toughness) under Static Loading (in Russian). Introduced 01.01.86. 4. Irvin Y.R. (1962). J.Appl.Mech., No. 4, 651. 5. Krasowskii A.Ya., Kashtalyan Yu.A., and Krasiko V.N. (1982). Investigation of Fracture Toughness of Pressure Vessel Steels under Sytatic and Dynamic Loading Considering the Size-Scale Effect of the Tested Specimens (in Russian), Preprint, Inst. For Problems of Strength, Kiev, Ukraine.

RkJQdWJsaXNoZXIy MjM0NDE=