ICF10B

a) Effect of sheet bonding length As shown in Figure 4(a), with a given hole diameter, the maximum load increased as the sheet bonding length was increased. However, it was confirmed that the gradient of the load-displacement curve remained almost the same even when the sheet bonding length was changed. b) Effect of hole diameter As shown in Figure 4(b), the larger the hole diameter, the larger was the starting load (about 1 kN for No.1, about 9 kN for No.4, about 17 kN for No.5). However, even when the hole diameter was changed, the gradient of the load-displacement curve remained almost the same. As shown in Figure 5, the relationship between indenter vertical displacement and sheet peeling length is almost linear. With a given amount of vertical displacement of the concrete indenter, the larger the hole diameter, the greater is the sum of the sheet peeling length and the hole radius. Because of this, the larger the hole diameter, the higher was the maximum load of punching shear at a given amount of indenter vertical displacement. 0 200 400 600 800 0 20 40 60 displacement mm peeling length a + radius of indenter ro mm 0゜ 90゜ 180゜No.1 270゜ 0゜ 90゜ 180゜No.4 270゜ No.1 Standard φ =200, L=500mm No.4 φ =500, L=500mm Figure 5:Relationship between peeling length and indenter vertical displacement (No.1,4) 4.COMPARISON BETWEEN ANALYTICAL AND EXPERIMENTAL RESULTS 4.1 Analytical technique Figure 6 shows the equilibrium of forces between vertical load P applied to the indenter and tensile force of the CFS. In this figure, α, a, ro, and L represent peeling angle in fiber orientation, sheet peeling length, indenter radius, and sheet bonding length respectively. Analyses were conducted on the assumption that when the sheet is bonded in two layers, one orthogonal to the other, the peeling zone becomes square in form when the steady state is reached. Using Young’s modulus of CFS E, CFS thickness t, indenter radius ro, sheet peeling length a, and indenter vertical displacement u, load applied to the indenter P, can be expressed as follows 2).         +β = ⋅ ⋅ ⋅ + ⋅β⋅ − 2 0 1 1 P 4 E t (r a) 1 , β= = α tan a u (1) Fracture energy, G, can be obtained by the following equation.       ⋅ ⋅β − +β + + − ⋅ ⋅         − +β = ⋅ ⋅ ⋅β + 1 1 2 1 a r a 1 E t 1 1 2 1 G E t 2 2 0 2 2 (2) When the sheet peeling length is sufficiently greater than the indenter radius, fracture energy, G, can be expressed as follows.         − +β = ⋅ ⋅ +β + 2 1 1 G E t 1 2 2 (3)

RkJQdWJsaXNoZXIy MjM0NDE=