propagation is commonly dealt with using fracture mechanics principles; but so far little attention has been paid in this direction. OBJECTIVES The insufficient attention on studies related to fracture behaviour of sheet metals originates from the fact that engineering materials with thinner sections are not considered as load bearing structural parts. Only Liu and his co-workers [2-4] have suggested some guidelines to assess fracture criteria of thin and tough plates of structural materials. The objectives of this study are (i) to present a simple technique for obtaining fracture criteria of EDD steel sheets in line with the studies of Liu [2], Ray [1] and verify the same with FE analysis. (ii) to examine the effect of the variation of thickness of such steel sheets on their fracture criteria. BACKGROUND The basic principle for obtaining fracture criteria of thin and tough sheets / plates according to Liu and his co-workers [2-4] is related to examinations of a strip necking zone which remains embedded inside the plastic zone ahead of a crack tip in a deformed specimen. The investigators have contended that such strip necking phenomenon is governed by the ratio of the plastic zone size and the plate thickness (B), and thus a physical parameter (K/ SY) 2/B controls the occurrence of crack tip necking. The parameter henceforth will be referred to as the strip necking parameter. In addition, Liu [2], and Liu and Kuo [4] have observed that the crack tip opening displacement in the strip necking zone is equal to the thickness contraction. This observation led them to conclude that the thickness contraction at the crack tip is equal to the crack tip opening displacement (CTOD), which in turn is related to the stress intensity factor. Thus, a measurement of the thickness contraction at the critical point of surface crack initiation leads to the assessment of a fracture criterion for thin and tough sheets and plates. But these investigations have not indicated any rationale for detecting the crack initiation event. METHODOLOGY The determination of fracture criterion for thin sheets in the present study was made using compact tension type specimens as per ASTM standard E399-91 [5] and with the help of a fabricated grip. The various tests are conducted to summarize the results. SPECIMEN PREPERATION Specimen is fabricated according to ASTM standard E399-91 [5] by wire electric discharge machining to maintain the exact relationship between all the dimensions. The configuration of the test specimen is shown in Fig.1. The specimens were ground with emery papers following 1/0 (coarse), 2/0, 3/0, 4/0 (fine). These were then polished first using alundum and finally using 0.25mm diamond paste. The mechanical grip was fabricated suitable to the Universal Testing Machine.
RkJQdWJsaXNoZXIy MjM0NDE=