of the (dimensionless) three-point bending compliance ψ (a/W, L/W) Modelization In order to take into account the influence of specimen mass distribution and its variation with varying specimen length, a refinement of the model proposed in [1] was worked out [10]. Use of this model to extract the moment acting at the crack tip from the records of the apparent load measured at the striker tup is very promising. An example of its capability to simulate the test and reproduce the experimental load-time traces is shown in Fig.7. 0 100 200 300 0 0.2 0.4 0.6 0.8 1 Load (N) Time (ms) L/W=7.5 a/W=0.5 Figure 7 – Comparison of experimental (dotted line) and calculated (full line) load-time trace obtained from a one-point bending impact test on a specimen with a/W=0.5 and L/W=7.5. CONCLUSIONS The analysis of the force-time traces recorded in one-point bending impact tests performed on single-edge notched specimens of varying geometry and mass distribution allowed us to identify the origin of several features of the impact process. Based on these observations a further refinement of existing models for the test simulation was worked out, so that the model can be used to extract dynamic fracture toughness values from the impact test. ACKNOWLEDGEMENTS The impact instrument used in this work has been graciously loaned by CEAST, Turin. This work is part of the thesis submitted by G.B. to Politecnico di Milano for his diploma degree in Chemical Engineering. REFERENCES 1. Pavan, A. and Draghi, S. (2000). In: Fracture of Polymers, Composites and Adhesives, ESIS 27, pp.347361, Williams, J.G. and Pavan, A. (Eds). Elsevier, Amsterdam. 2. ISO 13586:2000. Plastics - Determination of fracture toughness (GIC and KIC) - Linear elastic fracture mechanics (LEFM) approach. 3. ASTM D 5045-93. Standard Test Methods for Plane-Strain Fracture Toughness and Strain Energy Release Rate of Plastic Materials. 4. Böhme, W. and Kalthoff, J. F. (1982). Int. J. Fracture 20, R139. 5. Zanichelli, C., Rink, M., Riccò, T. and Pavan, A. (1990) Polym. Eng. Sci. 30, 1117-1124.
RkJQdWJsaXNoZXIy MjM0NDE=