Wells induced the empirical formula for COD according to the test results of wide-plate specimen with small crack: ea π δ 2= (1) In early 1980s, we found if the strain reaches several times the material yield strain when we conduct experimental research on fracture and fatigue of the nozzle, Formula (1) is too conservative, so we derived the formula below from Neuber relation[4]: ea π δ = (2) Cai Cigung[5] and Mercle[6] give the J-integral expression for full-yield model: ∫ = a de J σ π2 (3) In recent 20 years, various forms of COD expression at high strain were all obtained based on the above expression by adopting an appropriate safety factor. The COD expression adopted in PD6493-80, 91 for high strain: 0 .25 ) ( / 2 − = y y e a e e π δ (4) Chinese CVDA Code adopts COD expression for high strain: ) ( y a e e + = π δ (5) These COD expressions are all basically based on the wide-plate tests that seek full-yield state. Because the stress-strain field of wide plate is uniform, which is very different from high-strain zone of engineered construction such as pressure vessel nozzle etc., application of δ calculation method obtained from wide-plate test results to high-strain zone of practical engineered construction will yield a big deviation. By deriving from Dugdale’s COD expression for strip yield model and Cai Cigung’s J-integral expression for full yield model, we get unified expressions for various states of stress within the entire range from low stress to high strain, i.e.: 2 ( ) y y m ae σ σ π δ= ) 1 ( π σ σ ≤ y (6) ae m 1 =δ ) 1 ( π σ σ > y y e e 或 (7) when σ/σy=1/π, m aey π δ δ = = (7) (6) (8) where m is COD reduction factor. For flat stress, m=1; for flat strain, m=2; for most practical constructions between them, m=1.5. After considering 2 times safety factor, we get the following expressions: 2 ( ) 2 y y m ae σ σ π δ= ) 1 ( π σ σ ≤ y (9) m ae 2 =δ ) 1 ( π σ σ > y y e e 或 (10) 3.2 Measured Results Of Rotational Factor Of Crack Mouth Opening Displacement And COD 3.2.1Test contents (1) Based on strain measurement on SCT specimen without cracks, cut a manual notch at right side of the opening using linear cutting machine. Attach 5 pairs of cutting edge diagonally in front of crack tip, as shown in Fig. 4. (2) Prefabricate fatigue crack at a load of 0~6kN, stop when we can see 1~2mm fatigue crack on the surface with our eyes. (3) Take two pieces of specimen with respective Ф15mm and Ф20mm specially for test calibration of rotational factor r. Determine rotational factor r according to position of cutting edge, opening displacement and total length of cracks (calculate from position of loading line). 3.2.2Test results and analysis (1) Measured results of rotational factor for crack mouth opening displacement and COD The conversion from crack mouth opening displacement V to COD δ can be carried out with the following formula: Fig. 4 Arrangement of lateral cutting edge for SCT specimen 3
RkJQdWJsaXNoZXIy MjM0NDE=