ICF10B

0 50 100 150 0 1 2 3 4 5 6 Stress (MPa) Position (mm) Figure 3: Typical results of bending tests. Inset shows the relative fiber orientation for these data. DISCUSSION Probable Failure Scenario The clean fracture surface as well as the location and geometry of crack “2” support the hypothesis that the wheel fractured along crack 2 under application of a bending load as the wheel was cutting the brass bar. At the edge of the mounting flange, this stress would be concentrated due to sharp or uneven bearing surfaces between the flanges and the wheel. The cracking pattern suggests that failure initiated at the mounting flange and ran circumferentially around the flange. As the crack propagated it branched outward. It is important to emphasize, again, that a blotter pad was not used between the flange and the wheel. The circumferential stress concentration at the mounting flange damaged the fibers underneath the flange. These fibers are essential to the damage tolerance of the wheel, allowing for graceful failure, and large failure strains. In fact, if the fibers are properly utilized, the wheel fragments should hit the safety guard before any fibers have broken. The fibers are intended to pull-out and bridge the cracks in the underling matrix. However, the contact stress generated by the mounting flange damaged the fibers, causing localized fracture at the contact site. As a result, the fibers did not bridge the crack in the wheel and catastrophic failure ensued. The effectiveness of fiber reinforcing to increase the fracture toughness of a brittle material is demonstrated through the experimental results reported above. The fracture tests presented in Figure 2 and summarized in Table 1 clearly show that the bulk of the toughness comes from fiber bridging stresses. Furthermore, that toughness was shown to depend upon the fiber orientation relative to the crack plane: perpendicular fibers offering the greatest energy absorption. The material testing clearly indicates the effect of fiber orientation on the energy which is absorbed during failure, and show the same trend in the effect of fiber orientation on comparative fracture toughness. The energy required to break fibers which are aligned with the load direction is much greater than that required to delaminate fibers which are at or near 45° to the load direction. If all the cracks in the abrasive wheel had been bridged by transverse fibers, the wheel would have failed, but in a safe manner. This requires redesign of the reinforcing fiber directions to ensure that there are fibers in the principal loading directions of the wheel. CONCLUSIONS Most probable cause The wheel failed as a result of rapid crack propagation through the matrix, initiated at areas of concentrated stress due to the flanges bearing on the wheel. This failure became catastrophic when the layer of reinforcing fibers which bridged the cracks delaminated on two cracks and broke on a further two.

RkJQdWJsaXNoZXIy MjM0NDE=