ICF10B

Remedial action Redesign It is desired that wheels should never fail. However, once they do fail, it is imperative that they should remain safe. Given the finite probability of failure which always exists when using a brittle material, emphasis should be given to damage tolerant design, to reduce the catastrophic effect of failure. In particular, design of cutoff wheels should be appropriate to the hostility of the operating conditions, and should assume a level of mishandling and abuse. It is recommended that a different weave pattern should be used for the layer of reinforcing fibers on the abrasive wheel. A radial / circumferential weave pattern could be used with minimal increase in manufacture cost, resulting in a more damage tolerant product, with reinforcing fibers perpendicular to both principal loading directions. Implement Safety Procedures Crack initiation may not have occurred had the bearing surfaces on the flanges been properly maintained, or a blotter or compressible washer been used. Injury could have been prevented even in the case of catastrophic failure if the safety regulations laid down in the relevant standard [1] had been observed. Operators of abrasive wheels should recognize that there is always a risk of failure, and should take appropriate precautions. REFERENCES 1. ANSI B7.1-1988 American National Standard – Safety Requirements for the use, care and protection of abrasive wheels 2. ASTM E-399. (1990). Annual Book of ASTM standards, Section 3, Metals Test Methods and Analytical Procedures, ASTM, Philadelphia. 3. Cox, B. N. and Zok, F. W., “Advances in ceramic composites reinforced by continuous fibers,” Current Opinion in Solid State & Materials Science, vol. 11, No. 5, pp. 666-73, Oct. 1996. 4. Ewalds, H.L. and Wanhill, R.J.H. (1993). Fracture Mechanics. Edward Arnold Publishing, The Netherlands. 5. Chawla, K.K. (1987). Composite Materials. Springer-Verlag, Germany.

RkJQdWJsaXNoZXIy MjM0NDE=