ICF10B

ICF100249OR FATIGUE AND FRACTURE BEHAVIOUR OF A LASER HEAT TREATED MARTENSITIC HIGH-NITROGEN TOOL STEEL M.Heitkemper1, C.Bohne2, A.Pyzalla2, A.Fischer1 1Werkstofftechnik, Universitaet Essen, 45117 Essen, Germany 2Hahn-Meitner Institut, Abt. Werkstoffe, 14109 Berlin, Germany ABSTRACT High nitrogen tool steels offer a superior corrosion resistance compared to conventional, Nitrogen-free tool steels at similar mechanical and tribological properties. For this reason they are nowadays applied for ball bearings in aircraft industry. A laser-surface treatment can lead to a further improvement of this combination of properties. The aim of a research project is to improve the tribological properties and at the same time keep up or enhance the corrosion resistance as well as the fatigue behaviour. The laser heattreatment leads to a mixture of martensite and retained austenite. Thus, the martensitic regions show an increased hardness of about 700 HV10, while the austenitic regions are as soft as 400 HV10. To determine the influence of a laser-surface treatment on fatigue cyclic 4-point-bending tests in laboratory air as well an in artificial sea water (3%NaCl, 25°C) have been performed. The fatigue and fracture behaviour are mostly influenced by the refinement of the microstructure and the generation of compressive residual stresses. In addition the retained austenite and its stress induced transformation into martensite affects the fatigue behaviour. The residual stresses generated during heat treatment have a significant influence on crack initiation, while those generated during the transformation of the retained austenite have only a minor influence on crack propagation. KEYWORDS laser surface heat treatment, high-Nitrogen tool steel, fatigue, fracture mechanics, corrosion, residual stresses INTRODUCTION Martensitic high-Nitrogen steels (HNS) offer a favourable combination of tribological, chemical and mechanical properties. While the wear behaviour is comparable to conventional tool steels the corrosion resistance is significantly higher. For this reason they are already applied as materials for roller bearings of gas turbines and fuel pumps as well as for ball screws of thread gears in aerospace applications [1, 2, 3]. The good wear behaviour can be attributed to the fine dispersion of precipitates, which is governed by Nitrogen. The reason for the improved corrosion resistance is brought about by the high contents of Cr, Mo and N dissolved within the martensitic matrix. In many cases it is necessary to use cold-work tool steels in a tempered state in order to reduce the amount of retained austenite. In this heat treated condition Cr, Mo, and N are bound within precipitates. Within a DFG (German Research Council) funded research project the effect of a surface heat treatment by laser on microstructure and properties of HNS is investigated. During this kind of short time heat treatment nitrides are partly dissolved and new martensite is generated [4]. The dissolution of nitrides lays off some Cr and N and increases the resistance against pitting corrosion [5]. The

RkJQdWJsaXNoZXIy MjM0NDE=